AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0330 1998 Ford F150

P0330 1998 Ford F150 Code - Knock Sensor 2 Circuit Malfunction Bank 2

- Code Popularity: 2,362 Views
- Repair Importance Level: 2/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0330 1998 Ford F150?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Knock Sensor 2 Bank 2
  • Knock Sensor 2 Bank 2 circuit poor electrical connection
  • Knock Sensor 2 Bank 2 harness is open or shorted
  • Faulty Engine Control Module (ECM)
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0330 1998 Ford F150?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

The P0330 code means that the Knock Sensor is not working properly. Problems with the knock sensor will not cause an engine performance problems. Replacing the knock sensor usually takes care of the problem.
The knock sensor detects vibration upon increase and decrease in engine rpm. The knock sensor generates a voltage based on this vibration. Should this voltage go outside a calibrated level a DTC will set.

Search for P0330 1998 Ford F150 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0330 1998 Ford F150 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

An excessively low or high voltage from the sensor is sent to Engine Control Module (ECM)

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine Lack / Loss of Power

Code P0330 1998 Ford F150 Description

The knock sensor is attached to the cylinder block. It senses engine knocking using a piezoelectric element. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the Engine Control Module (ECM).

OBDII Code P0330 1998 Ford F150 - Knock Sensor 2 Circuit Malfunction Bank 2  - AutoCodes.com
P0330 1998 Ford F150 Code - Knock Sensor 2 Circuit Malfunction Bank 2

Need More Information on the Code?

Need more information on how to fix the P0330 1998 Ford F150 code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0330 1998 Ford F150 code diagnosed by a professional: Find a repair shop in your area

Code P0330 1998 Ford F150 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0330 1998 Ford F150 code? Have you replaced any parts?
Any information is appreciated. Thanks