Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
The cost of diagnosing the P02D0 BMW code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
Zero Fuel Calibration (ZFC) is an algorithm used to detect deviations in individual injector performance from nominal. In an overrun/decel fuel shut-off condition, fuel rail pressure is set to 300 bar and small injections are made from a single injector. The observed acceleration in crankshaft speed is detected and compared to the expected acceleration. If the observed acceleration deviates from the expected acceleration by more than 50%, then an additional routine is called adjusts the injection energizing time until observed acceleration matches expected. This information is then used to adjust all pilot injections on that injector to ensure correct fuel delivery. If the absolute energizing time observed for the test injection to yield the expected acceleration exceeds minimum or maximum limits, a code is set.
The Powertrain Control Module (PCM) sets the OBDII code when the observed energizing time for the test injection is 156 us or more lower than the target 430 us energizing time for the given injector.
Need more information on how to fix the P02D0 BMW code? Get Access to Factory Service Manuals
Get the P02D0 BMW code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P02D0 BMW code? Have you replaced any parts?
Any information is appreciated. Thanks