AutoCodes - Ford - P0298 2008 FORD FUSION

P0298 2008 FORD FUSION Code - Engine Oil Over Temperature Condition

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|P0298 2008 FORD FUSION code possible causes

  • Low or dirty motor oil condition
  • Faulty Oil Pressure Switch
  • Faulty Engine Oil Temperature (EOT) sensor
  • Engine overheating condition
  • Very high engine RPM for an extended period of time

|How do I fix the P0298 2008 FORD FUSION code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P0298 2008 FORD FUSION code tech notes

On engines which are equipped with an oil temperature sensor, the Engine Control Module (ECM) reads oil temperature to determine if it is excessive. When an oil temperature sensor is not present, the ECM uses an oil algorithm to infer actual temperature. Engine shutdown strategy function is the same on vehicles with and without oil temperature sensors.

|Cost of diagnosing the P0298 2008 FORD FUSION code

Labor: 1.0

The cost of diagnosing the P0298 2008 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P0298 2008 FORD FUSION code detected?

P0298 is set when the vehicle has been running below 1,000 rpm and less than 20 mg/stroke MFDES with EOT sensor signal reading above 110 C (230 F). The time to set the fault is dependent on EOT and Intake Air Temperature (IAT) temperatures, and can vary between approx. 15 to 45 minutes

|What are P0298 2008 FORD FUSION code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|P0298 2008 FORD FUSION code description

Indicates the engine oil temperature protection strategy in the powertrain control module (PCM) has been activated. This temporarily prohibits high engine speed operation by disabling injectors, to reduce the risk of engine damage from high engine oil temperature. On engines equipped with an oil temperature sensor, the PCM reads oil temperature to determine if it is excessive. When an oil temperature sensor is not present, the PCM uses an oil algorithm to determine actual temperature. Engine shutdown strategy function is the same on vehicles with and without oil temperature sensors.
OBDII Code P0298 2008 Ford Fusion - Engine Oil Over Temperature Condition - AutoCodes.com

|Need more information with the P0298 2008 FORD FUSION code?

Need more information on how to fix the P0298 2008 FORD FUSION code? Get Access to Factory Service Manuals

|Need help with a P0298 2008 FORD FUSION code?

Get the P0298 2008 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

|P0298 2008 FORD FUSION code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0298 2008 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?