P0298 2002 FORD F150 Code - Engine Oil Over Temperature Condition
|P0298 2002 FORD F150 code possible causes
- Engine overheating condition
- Very high engine RPM for an extended period of time
- Low or dirty motor oil condition
- Faulty Oil Pressure Switch
- Faulty Engine Oil Temperature (EOT) sensor
|How do I fix the P0298 2002 FORD F150 code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|P0298 2002 FORD F150 code tech notesIndicates the Engine Oil Temperature Protection strategy in the PCM has been activated. This will temporarily prohibit high engine speed operation by disabling injectors, therefore reducing the risk of engine damage from high engine oil temperature. Note: On engines which are equipped with an oil temperature sensor, the PCM reads oil temperature to determine if it is excessive. When an oil temperature sensor is not present, the PCM uses an oil algorithm to infer actual temperature. Engine shutdown strategy function is the same on vehicles with and without oil temperature sensors.
|Cost of diagnosing the P0298 2002 FORD F150 code
Labor: 1.0The cost of diagnosing the P0298 2002 FORD F150 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0298 2002 FORD F150 code detected?P0298 is set when the vehicle has been running below 1,000 rpm and less than 20 mg/stroke MFDES with EOT sensor signal reading above 110 C (230 F). The time to set the fault is dependent on EOT and Intake Air Temperature (IAT) temperatures, and can vary between approx. 15 to 45 minutes
|What are P0298 2002 FORD F150 code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|P0298 2002 FORD F150 code descriptionIndicates the Engine Oil Temperature Protection (EOT) strategy in the Engine Control Module (ECM) has been activated. This temporarily prohibits high engine speed operation by disabling injectors, reducing the risk of engine damage from high engine oil temperature.
|Need more information with the P0298 2002 FORD F150 code?Need more information on how to fix the P0298 2002 FORD F150 code? Get Access to Factory Service Manuals
|Need help with a P0298 2002 FORD F150 code?Get the P0298 2002 Ford F150 code diagnosed by a professional: Find a repair shop in your area
|P0298 2002 FORD F150 code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0298 2002 Ford F150 code? Have you replaced any parts?
Any information is appreciated. Thanks