AutoCodes.com | All About OBDII Engine Codes
AutoCodes - BMW - P0264 BMW

P0264 BMW Code - Cylinder 2 Fuel Injector Circuit Low

- Code Popularity: 4,933 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0264 BMW?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Dirty Fuel Injector 2
  • Faulty Fuel Injector 2
  • Plugged Fuel Injector 2
  • Fuel Injector #2 harness is open or shorted
  • Fuel Injector #2 circuit poor electrical connection
⚠ Does your BMW have Safety Recalls? → Check here

How to Fix the DTC P0264 BMW?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Clogged or partially clogged fuel injector can cause this code. Start by performing an injector flush before replacing the injector.

Search for P0264 BMW Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0264 BMW code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine Misfire
  • Engine Run Rough
  • Low MPG

Code P0264 BMW Description

This fault code is stored in the Engine Control Module (ECM) when the injector control circuit does not behave as expected. The ECM uses the induced voltage from the injector to indicate that the fuel injector circuit is operating correctly electrically. It does not signal the mechanical condition of the injector. When the ECM opens the ground circuit for an injector, to cease current flow, a voltage is induced into the winding. This voltage shows the electrical integrity of the injector and associated wiring. Absence of this induced voltage results in a fault code being stored in the ECM.

OBDII Code P0264 BMW - Cylinder 2 Fuel Injector Circuit Low - AutoCodes.com
P0264 BMW Code - Cylinder 2 Fuel Injector Circuit Low

Need More Information on the Code?

Need more information on how to fix the P0264 BMW code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0264 BMW code diagnosed by a professional: Find a repair shop in your area

Code P0264 BMW comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0264 BMW code? Have you replaced any parts?
Any information is appreciated. Thanks