AutoCodes - Ford - P0230 2010 FORD FUSION

P0230 2010 FORD FUSION Code - The ECM Has Detected A Fault In The Fuel Pump Circuit

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|P0230 2010 FORD FUSION code possible causes

  • Blown Fuel Pump fuse
  • Open Fuel Pump Monitor Circuit
  • Faulty Fuel Pump Relay
  • Damaged ECM

|How do I fix the P0230 2010 FORD FUSION code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P0230 2010 FORD FUSION code tech notes

For some FORD models:
1. Disconnect the inertia switch harness connector
2. Turn key to ON position (Engine OFF)
3. Measure voltage of circuit between inertia switch harness connector and ground
4. If battery voltage is found, replaced Inertia Switch
5. Clear codes.

|Cost of diagnosing the P0230 2010 FORD FUSION code

Labor: 1.0

The cost of diagnosing the P0230 2010 FORD FUSION code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P0230 2010 FORD FUSION code detected?

The code will be set if an incorrect voltage on the control circuit of the fuel pump relay is detected by the ECM.

|What are P0230 2010 FORD FUSION code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|P0230 2010 FORD FUSION code description

The powertrain control module (PCM) monitors the fuel pump (FP) circuit output from the PCM. The test fails when the FP output is commanded ON (grounded) and excessive current draw is detected on the FP circuit. The test also fails when the FP output is commanded OFF and voltage is not detected on the FP circuit. The PCM expects to detect VPWR voltage coming through the fuel pump relay coil to the FP circuit
OBDII Code P0230 2010 Ford Fusion - The ECM Has Detected A Fault In The Fuel Pump Circuit - AutoCodes.com

|Need more information with the P0230 2010 FORD FUSION code?

Need more information on how to fix the P0230 2010 FORD FUSION code? Get Access to Factory Service Manuals

|Need help with a P0230 2010 FORD FUSION code?

Get the P0230 2010 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

|P0230 2010 FORD FUSION code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0230 2010 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?