AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Infiniti - P0226 2003 Infiniti G35

P0226 2003 Infiniti G35 Code - Throttle/Pedal Position Sensor/Switch 'C' Circuit Range/Performance Problem

- Code Popularity: 10,294 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0226 2003 Infiniti G35?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Throttle Position Sensor (TPS)
  • Throttle Position Sensor (TPS) harness is open or shorted
  • Throttle Position Sensor (TPS) circuit poor electrical connection
⚠ Does your Infiniti have Safety Recalls? → Check here

How to Fix the DTC P0226 2003 Infiniti G35?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0226 2003 Infiniti G35 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0226 2003 Infiniti G35 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

An out of range voltage from the Throttle Position Sensor (TPS) is sent to Engine Control Module (ECM).

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • No throttle response

Code P0226 2003 Infiniti G35 Description

The accelerator pedal position sensor is installed on the upper end
of the accelerator pedal assembly. The sensor detects the accelerator
position and sends a signal to the ECM.
Accelerator pedal position sensor has two sensors. These sensors
are a kind of potentiometers which transform the accelerator pedal
position into output voltage, and emit the voltage signal to the ECM.
In addition, these sensors detect the opening and closing speed of
the accelerator pedal and feed the voltage signals to the ECM. The
ECM judges the current opening angle of the accelerator pedal from
these signals and controls the throttle control motor based on these
signals.
Idle position of the accelerator pedal is determined by the ECM
receiving the signal from the accelerator pedal position sensor. The ECM uses this signal for the engine operation
such as fuel cut.
OBDII Code P0226 2003 Infiniti G35 - Throttle/Pedal Position Sensor/Switch 'C' Circuit Range/Performance Problem - AutoCodes.com
P0226 2003 Infiniti G35 Code - Throttle/Pedal Position Sensor/Switch 'C' Circuit Range/Performance Problem

Need More Information on the Code?

Need more information on how to fix the P0226 2003 Infiniti G35 code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0226 2003 Infiniti G35 code diagnosed by a professional: Find a repair shop in your area

Code P0226 2003 Infiniti G35 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0226 2003 Infiniti G35 code? Have you replaced any parts?
Any information is appreciated. Thanks