AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0198 2011 Ford Fusion

P0198 2011 Ford Fusion Code - Engine Oil Temperature Sensor Circuit High Input

- Code Popularity: 1,850 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0198 2011 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Engine Oil Temperature sensor
  • Engine Oil Temperature sensor harness is open or shorted
  • Engine Oil Temperature sensor circuit poor electrical connection
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0198 2011 Ford Fusion?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0198 2011 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0198 2011 Ford Fusion code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The P0198 indicates the Engine Oil Temperature Sensor signal voltage is hign (low temperature). An EOT PID reading greater than 4.5 volts with the ignition ON engine OFF or during any engine operating mode indicates a concern is present.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0198 2011 Ford Fusion Description

The Powertrain Control Module (PCM) monitors the Engine Oil Temperature (EOT) Sensor. The PCM sets the Diagnostic Trouble Code (DTC) when the Engine Oil Temperature Sensor is not to factory specifications. Indicates Engine Oil Temperature signal voltage is high (low temperature).

OBDII Code P0198 2011 Ford Fusion - Engine Oil Temperature Sensor Circuit High Input - AutoCodes.com
P0198 2011 Ford Fusion Code - Engine Oil Temperature Sensor Circuit High Input

Need More Information on the Code?

Need more information on how to fix the P0198 2011 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0198 2011 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Code P0198 2011 Ford Fusion comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0198 2011 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks