AutoCodes.com | All About OBDII Engine Codes
AutoCodes - GMC - P0160 GMC

P0160 GMC Code - O2 Sensor Circuit No Activity Detected Bank 2 Sensor 2

- Code Popularity: 11,674 Views
- Repair Importance Level: 2/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0160 GMC?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Rear Heated Oxygen Sensor Bank 2
  • Rear Heated Oxygen Sensor Bank 2 harness is open or shorted
  • Rear Heated Oxygen Sensor Bank 2 circuit poor electrical connection
  • Inappropriate fuel pressure
  • Faulty fuel injectors
  • Intake air leaks may be faulty
  • Exhaust gas leaks
⚠ Does your GMC have Safety Recalls? → Check here

How to Fix the DTC P0160 GMC?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Replacing the Rear Heated Oxygen Sensor Bank 2 usually takes care of the problem

Search for P0160 GMC Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0160 GMC code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The Powertrain Control Module (PCM) monitors the HO2S voltage and detects if the voltage goes out of the bias range. If the PCM does not detect the voltage went out of the bias range, the P0160 code will set.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • High Fuel Consumption
  • Excessive Smoke from Exhaust

Code P0160 GMC Description

The Powertrain Control Module (PCM) supplies a voltage of about 450 mV between the HO2S high and low signal circuits. The oxygen sensor varies the voltage over a range from about 1,000 mV when the exhaust is rich, down through about 10 mV when the exhaust is lean.
The PCM monitors and stores the heated oxygen sensor (HO2S) voltage information. The PCM evaluates the HO2S voltage samples in order to determine the amount of time the HO2S voltage was out of range. The PCM compares the stored HO2S voltage samples taken within each sample period and determines if majority of the samples are out of the operating range.

OBDII Code P0160 GMC - O2 Sensor Circuit No Activity Detected Bank 2 Sensor 2 - AutoCodes.com
P0160 GMC Code - O2 Sensor Circuit No Activity Detected Bank 2 Sensor 2

Need More Information on the Code?

Need more information on how to fix the P0160 GMC code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0160 GMC code diagnosed by a professional: Find a repair shop in your area

Code P0160 GMC comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0160 GMC code? Have you replaced any parts?
Any information is appreciated. Thanks