AutoCodesChevrolet – P0157 2014 Chevrolet Silverado

P0157 2014 Chevrolet Silverado Code - HO2S Circuit Low Voltage Bank 2 Sensor 2

Quick Answer

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Common causes include Faulty Rear Heated Oxygen Sensor Bank 2, Rear Heated Oxygen Sensor Bank 2 harness is open or shorted, Rear Heated Oxygen Sensor Bank 2 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

What it means
P0157 2014 Chevrolet Silverado indicates HO2S Circuit Low Voltage Bank 2 Sensor 2.
Common causes
Common causes include Faulty Rear Heated Oxygen Sensor Bank 2, Rear Heated Oxygen Sensor Bank 2 harness is open or shorted, Rear Heated Oxygen Sensor Bank 2 circuit poor electrical connection.
Severity
Moderate - service should be scheduled soon.
Can I drive?
The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
AI answers can be wrong. Verify repairs with testing. Open full chat
Code Popularity 418
How popular is this code, among other codes? Low
Table of contents Created and updated by William Orellana on May 27, 2022
💬 Need more help? Ask Coddy for instant answers — it's free!

Code P0157 2014 Chevrolet Silverado Description

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Each HO2S compares the oxygen content of the surrounding air with the oxygen content of the exhaust stream. When the engine is started, the Engine Control Module (ECM) operates in an Open Loop mode, ignoring the HO2S signal voltage while calculating the air-to-fuel ratio. While the engine runs, the HO2S heats up and begins to generate a voltage within a range of 0 - 1, 000 mV. Once sufficient HO2S voltage fluctuation is observed by the ECM, Closed Loop is entered. The ECM uses the HO2S voltage to determine the air-to-fuel ratio. An HO2S voltage that increases toward 1, 000 mV indicates a rich fuel mixture. An HO2S voltage that decreases toward 0 mV indicates a lean fuel mixture.
The heating elements inside each HO2S heat the sensor to bring the sensor up to operating conditions faster. This allows the system to enter Closed Loop earlier and the ECM to calculate the air-to-fuel ratio sooner.
The Diagnostic Trouble Code (DTC) will be set when the ECM detects that the heated oxygen sensor is shorted to ground if the HO2S voltage is less than 50 mV.
OBDII Code P0157 2014 Chevrolet Silverado - HO2S Circuit Low Voltage Bank 2 Sensor 2 - AutoCodes.com
P0157 2014 Chevrolet Silverado Code - HO2S Circuit Low Voltage Bank 2 Sensor 2

What are the Possible Causes of the DTC P0157 2014 Chevrolet Silverado?

  • Faulty Rear Heated Oxygen Sensor Bank 2
  • Rear Heated Oxygen Sensor Bank 2 harness is open or shorted
  • Rear Heated Oxygen Sensor Bank 2 circuit poor electrical connection
  • Low or high fuel system pressure
  • Fuel contamination
  • Faulty fuel injectors
  • Exhaust gas leaks
  • Engine vacuum leaks

How to Fix the DTC P0157 2014 Chevrolet Silverado?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0157 2014 Chevrolet Silverado code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P0157 2014 Chevrolet Silverado code?

Need more information on how to fix the P0157 2014 Chevrolet Silverado code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0157 2014 Chevrolet Silverado code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P0157 2014 Chevrolet Silverado Code

What does the OBDII code P0157 mean on a 2014 Chevrolet Silverado?

P0157 indicates low voltage in the HO2S (Heated Oxygen Sensor) circuit for Bank 2 Sensor 2, which is the downstream oxygen sensor on the exhaust system of the second bank of cylinders.

What are the symptoms of code P0157 in a 2014 Chevrolet Silverado?

Symptoms may include reduced fuel efficiency, rough idling, poor engine performance, and possibly the illumination of the Check Engine Light.

What causes the P0157 code on a 2014 Chevrolet Silverado?

Common causes include a faulty Bank 2 Sensor 2 oxygen sensor, damaged wiring or connectors, exhaust leaks near the sensor, or even an issue with the engine control module (ECM).

Can driving with a P0157 code damage my 2014 Chevrolet Silverado?

While driving short-term may not cause severe damage, prolonged operation with this code could lead to increased emissions, reduced engine performance, and potential damage to the catalytic converter.

How do you fix a P0157 code on a 2014 Chevrolet Silverado?

Repairs may include inspecting and repairing sensor wiring, replacing the downstream oxygen sensor (Bank 2 Sensor 2), fixing any exhaust leaks, or updating the ECM software if necessary.

How do I know which oxygen sensor to replace for code P0157?

P0157 refers specifically to the downstream oxygen sensor (Sensor 2) on Bank 2, which is the side of the engine opposite Bank 1 (usually the side without Cylinder 1).

Can a dirty or clogged catalytic converter cause a P0157 code?

Yes, a restricted catalytic converter could affect the downstream oxygen sensor readings and potentially result in a P0157 code.

What tools are needed to diagnose and fix a P0157 code on a 2014 Chevrolet Silverado?

You’ll likely need an OBDII scanner, multimeter for testing wiring, and basic hand tools for removing and replacing the oxygen sensor.

How do I test the wiring for the oxygen sensor related to P0157?

Use a multimeter to check for continuity, shorts, and proper voltage in the wiring harness connected to Bank 2 Sensor 2.

Can a bad ECM cause the P0157 code in a 2014 Chevrolet Silverado?

While rare, a malfunctioning ECM can misinterpret sensor data and trigger a P0157 code. Testing and ruling out other causes first is recommended.

Discuss the causes and fixes for P0157 2014 Chevrolet Silverado OBDII Code

Code P0157 2014 Chevrolet Silverado comments

No comments found for this page.

AutoCodes App

Fix Your Car Smarter

Try the New AutoCodes App!

Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.

AutoCodes App on Google Play