AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - P014C 2011 Nissan Rogue

P014C 2011 Nissan Rogue Code - Air Fuel Ratio Sensor Slow Response - Rich To Lean Bank 1 sensor 1

- Code Popularity: 2,494 Views
- Repair Importance Level: 2/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P014C 2011 Nissan Rogue?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Air Fuel Ratio (A/F) Bank 1 Sensor 1
  • Air Fuel Ratio (A/F) Bank 1 Sensor 1 harness is open or shorted
  • Air Fuel Ratio (A/F) Bank 1 Sensor 1 circuit poor electrical connection
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P014C 2011 Nissan Rogue?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Replacing the Air Fuel Ratio Bank 1 Sensor 1 usually takes care of the problem.

Search for P014C 2011 Nissan Rogue Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P014C 2011 Nissan Rogue code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The response time of a A/F sensor 1 signal delays more than the specified time computed by Engine Control Module (ECM).

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • High Fuel Consumption
  • Excessive Smoke from Exhaust

Code P014C 2011 Nissan Rogue Description

The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor. The sensor element of the A/F sensor 1 is composed an electrode layer, which transports ions. It has a heater in the element. The sensor is capable of precise measurement λ = 1, but also in the lean and rich range. Together with its control electronics, the sensor outputs a clear, continuous signal throughout a wide λ range. The exhaust gas components diffuse through the diffusion layer at the sensor cell. An electrode layer is applied voltage, and this current relative oxygen density in lean. Also this current relative hydrocarbon density in rich.
Therefore, the A/F sensor 1 is able to indicate air fuel ratio by this electrode layer of current. In addition, a heater is integrated in the sensor to ensure the required operating temperature of approximately 760°C (1,400°F).

OBDII Code P014C 2011 Nissan Rogue - Air Fuel Ratio Sensor Slow Response - Rich To Lean Bank 1 sensor 1 - AutoCodes.com
P014C 2011 Nissan Rogue Code - Air Fuel Ratio Sensor Slow Response - Rich To Lean Bank 1 sensor 1

Need More Information on the Code?

Need more information on how to fix the P014C 2011 Nissan Rogue code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P014C 2011 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area

Code P014C 2011 Nissan Rogue comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P014C 2011 Nissan Rogue code? Have you replaced any parts?
Any information is appreciated. Thanks