AutoCodes
 
OBDII Code List
 
P0141 2010 TOYOTA CAMRY

P0141 2010 TOYOTA CAMRY - Oxygen Sensor Circuit Malfunction Bank 1 Sensor 2

Repair Importance Level: 2/3
Repair Difficulty Level: 2/3   
Comments  |  Add Comment

Possible causes

  • Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2
  • EFI Relay
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit fuse
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit open shorted to ground
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
  • Faulty Engine Control Module (ECM)

Tech notes

The code means that there is a problem with the heater element circuit of the heated oxygen sensor. The control module monitors how long it take the sensor to warm up and start sending an adequate signal. The code is triggered when the sensor is taking too long to warm up. Water getting inside the heated oxygen sensor connector can caused the heated oxygen sensor fuse to blow. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors. If the sensor and connector are OK, replacing the O2 Sensor 1 usually takes care of the problem

When is the code detected?

Current amperage in the rear heated oxygen sensor heater circuit is out of the normal range.

Possible symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Possible higher than usual fuel Consumption

P0141 2010 Toyota Camry Description

In order to obtain a high purification rate of the carbon monoxide (CO), hydrocarbon (HC) and nitrogen oxide (NOx) components in the exhaust gas, a TWC is used. For the most efficient use of the TWC, the air-fuel ratio must be precisely controlled so that it is always close to the stoichiometric air-fuel level. For the purpose of helping the ECM to deliver accurate air-fuel ratio control, a Heated Oxygen (HO2) sensor is used.

The HO2 sensor is located behind the TWC, and detects the oxygen concentration in the exhaust gas. Since the sensor is integrated with the heater that heats the sensing portion, it is possible to detect the oxygen concentration even when the intake air volume is low (the exhaust gas temperature is low). When the air-fuel ratio becomes lean, the oxygen concentration in the exhaust gas is rich. The HO2 sensor informs the ECM that the post-TWC air-fuel ratio is lean (low voltage, i.e. less than 0.45 V). Conversely, when the air-fuel ratio is richer than the stoichiometric air-fuel level, the oxygen concentration in the exhaust gas becomes lean. The HO2 sensor informs the ECM that the post-TWC air-fuel ratio is rich (high voltage, i.e. more than 0.45 V). The HO2 sensor has the property of changing its output voltage drastically when the air-fuel ratio is close to the stoichiometric level.

The ECM uses the supplementary information from the HO2 sensor to determine whether the air-fuel ratio after the TWC is rich or lean, and adjusts the fuel injection time accordingly. Thus, if the HO2 sensor is working improperly due to internal malfunctions, the ECM is unable to compensate for deviations in the primary air-fuel ratio control.

OBDII Code P0141 2010 Toyota Camry - Oxygen Sensor Circuit Malfunction Bank 1 Sensor 2 - AutoCodes.com

Need more help?

Get the P0141 2010 Toyota Camry code diagnosed by a professional: Find a repair shop in your area

Related Information

P0141 2010 TOYOTA CAMRY Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0141 2010 Toyota Camry code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧