AutoCodes – Pontiac – P013F Pontiac

P013F Pontiac Code - HO2S Delay Response Lean to Rich Bank 1 Sensor 2

Quick Answer

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Common causes include Faulty Heated Oxygen Bank 1 Sensor 2, Heated Oxygen Bank 1 Sensor 2 harness is open or shorted, Heated Oxygen Bank 1 Sensor 2 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

What it means: P013F Pontiac indicates HO2S Delay Response Lean to Rich Bank 1 Sensor 2.
Common causes: Common causes include Faulty Heated Oxygen Bank 1 Sensor 2, Heated Oxygen Bank 1 Sensor 2 harness is open or shorted, Heated Oxygen Bank 1 Sensor 2 circuit poor electrical connection.
Severity: Moderate - service should be scheduled soon.
Can I drive?: The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 2,332

How popular is this code, among other codes? Low

Repair Importance Level

Moderate (Service soon) (2 / 3)

Repair Difficulty Level

Intermediate (2 / 3)

What is this?

Table of contents Created and updated by William Orellana on May 28, 2022

Description
Possible Causes
How To Fix
Tech Notes
Cost to Diagnose
FAQs
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P013F Pontiac Description

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Each HO2S compares the oxygen content of the surrounding air with the oxygen content of the exhaust stream. When the engine is started, the Engine Control Module (ECM) operates in an Open Loop mode, ignoring the HO2S signal voltage while calculating the air-to-fuel ratio. While the engine runs, the HO2S heats up and begins to generate a voltage within a range of 0 - 1, 000 mV. Once sufficient HO2S voltage fluctuation is observed by the ECM, Closed Loop is entered. The ECM uses the HO2S voltage to determine the air-to-fuel ratio. An HO2S voltage that increases toward 1, 000 mV indicates a rich fuel mixture. An HO2S voltage that decreases toward 0 mV indicates a lean fuel mixture.
The heating elements inside each HO2S heat the sensor to bring the sensor up to operating conditions faster. This allows the system to enter Closed Loop earlier and the ECM to calculate the air-to-fuel ratio sooner.
The Diagnostic Trouble Code (DTC) will be set when the ECM detects that the O2 sensor voltage has not increased above 350 mV within a calibrated value of accumulated airflow.

OBDII Code P013F Pontiac - HO2S Delay Response Lean to Rich Bank 1 Sensor 2 - AutoCodes.com — P013F Pontiac Code - HO2S Delay Response Lean to Rich Bank 1 Sensor 2

What does this mean?

What are the Possible Causes of the DTC P013F Pontiac?

Faulty Heated Oxygen Bank 1 Sensor 2
Heated Oxygen Bank 1 Sensor 2 harness is open or shorted
Heated Oxygen Bank 1 Sensor 2 circuit poor electrical connection
Low or high fuel system pressure
Fuel contamination
Faulty fuel injectors
Exhaust gas leaks
Engine vacuum leaks

How to Fix the DTC P013F Pontiac?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What does this mean?

Code Tech Notes

Replacing the Rear Heated Oxygen Sensors (HO2S) usually takes care of the problem.

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P013F Pontiac code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P013F Pontiac code?

Need more information on how to fix the P013F Pontiac code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P013F Pontiac code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P013F Pontiac Code

1. What are the common symptoms of OBDII code P013F in a Pontiac?

- Common symptoms include rough idling, decreased fuel efficiency, engine misfires, and the illumination of the Check Engine light.

2. What does the OBDII code P013F indicate in a Pontiac?

- The code P013F indicates a delay in the response from the downstream oxygen sensor (Bank 1 Sensor 2) as the system switches from a lean to a rich air-fuel mixture.

3. What are the possible causes of OBDII code P013F in a Pontiac?

- Possible causes include a faulty oxygen sensor, wiring issues, exhaust leaks, vacuum leaks, fuel system problems, or issues with the engine's computer.

4. How can I diagnose the OBDII code P013F in my Pontiac?

- Diagnosing P013F typically involves using an OBDII scanner to retrieve the code, inspecting the downstream oxygen sensor, checking for any visible damage or leaks in the exhaust system, and testing the sensor's response time.

5. Can I continue driving my Pontiac with the OBDII code P013F?

- It is not recommended to continue driving with the P013F code illuminated, as it can lead to further engine damage and reduced fuel efficiency over time. It is best to address the issue promptly.

6. How can I repair OBDII code P013F in my Pontiac?

- Repairing P013F may involve replacing the downstream oxygen sensor, repairing any wiring or exhaust leaks, addressing fuel system issues, or reprogramming the engine's computer.

7. Is it possible to reset the OBDII code P013F in my Pontiac without fixing the underlying issue?

- While you can clear the code using an OBDII scanner, the Check Engine light is likely to reappear if the root cause of the code is not addressed. It is best to fix the problem to prevent recurring issues.

8. How much does it cost to repair OBDII code P013F in a Pontiac?

- The cost of repairing P013F can vary depending on the underlying issue, the labor rates in your area, and whether you choose to fix the problem yourself or take your vehicle to a mechanic. Costs may range from a few hundred to over a thousand dollars.

9. Can a DIY enthusiast fix OBDII code P013F in a Pontiac?

- Depending on your mechanical skills and access to tools, some DIY enthusiasts may be able to address the P013F code by replacing the oxygen sensor or fixing minor wiring issues. However, more complex problems may require professional assistance.

10. How long does it typically take to repair OBDII code P013F in a Pontiac?

- The repair time for P013F can vary based on the specific issue and your experience level. Simple fixes like replacing the oxygen sensor may take an hour or two, while more involved repairs could take several hours or even a day.