AutoCodesChevrolet – P013C 2016 Chevrolet Silverado

P013C 2016 Chevrolet Silverado Code - HO2S Slow Response Rich to Lean Bank 2 Sensor 2

Quick Answer

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Common causes include Faulty Heated Oxygen Bank 2 Sensor 2, Heated Oxygen Bank 2 Sensor 2 harness is open or shorted, Heated Oxygen Bank 2 Sensor 2 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

What it means
P013C 2016 Chevrolet Silverado indicates HO2S Slow Response Rich to Lean Bank 2 Sensor 2.
Common causes
Common causes include Faulty Heated Oxygen Bank 2 Sensor 2, Heated Oxygen Bank 2 Sensor 2 harness is open or shorted, Heated Oxygen Bank 2 Sensor 2 circuit poor electrical connection.
Severity
Moderate - service should be scheduled soon.
Can I drive?
The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
AI answers can be wrong. Verify repairs with testing. Open full chat
Code Popularity 518
How popular is this code, among other codes? Low
Table of contents Created and updated by William Orellana on May 28, 2022
💬 Need more help? Ask Coddy for instant answers — it's free!

Code P013C 2016 Chevrolet Silverado Description

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Each HO2S compares the oxygen content of the surrounding air with the oxygen content of the exhaust stream. When the engine is started, the Engine Control Module (ECM) operates in an Open Loop mode, ignoring the HO2S signal voltage while calculating the air-to-fuel ratio. While the engine runs, the HO2S heats up and begins to generate a voltage within a range of 0 - 1, 000 mV. Once sufficient HO2S voltage fluctuation is observed by the ECM, Closed Loop is entered. The ECM uses the HO2S voltage to determine the air-to-fuel ratio. An HO2S voltage that increases toward 1, 000 mV indicates a rich fuel mixture. An HO2S voltage that decreases toward 0 mV indicates a lean fuel mixture.
The heating elements inside each HO2S heat the sensor to bring the sensor up to operating conditions faster. This allows the system to enter Closed Loop earlier and the ECM to calculate the air-to-fuel ratio sooner.
The Diagnostic Trouble Code (DTC) will be set when the ECM detects that the accumulated mass airflow monitored during rich-to-lean transitions between 450 - 150 mV is greater than calibrated value.
OBDII Code P013C 2016 Chevrolet Silverado - HO2S Slow Response Rich to Lean Bank 2 Sensor 2 - AutoCodes.com
P013C 2016 Chevrolet Silverado Code - HO2S Slow Response Rich to Lean Bank 2 Sensor 2

What are the Possible Causes of the DTC P013C 2016 Chevrolet Silverado?

  • Faulty Heated Oxygen Bank 2 Sensor 2
  • Heated Oxygen Bank 2 Sensor 2 harness is open or shorted
  • Heated Oxygen Bank 2 Sensor 2 circuit poor electrical connection
  • Low or high fuel system pressure
  • Fuel contamination
  • Faulty fuel injectors
  • Exhaust gas leaks
  • Engine vacuum leaks

How to Fix the DTC P013C 2016 Chevrolet Silverado?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P013C 2016 Chevrolet Silverado code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P013C 2016 Chevrolet Silverado code?

Need more information on how to fix the P013C 2016 Chevrolet Silverado code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P013C 2016 Chevrolet Silverado code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P013C 2016 Chevrolet Silverado Code

What does the OBDII code P013C mean for a 2016 Chevrolet Silverado?

Code P013C indicates that the oxygen sensor (HO2S) on Bank 2 Sensor 2 is detecting a slow response when transitioning from a rich to a lean air-fuel mixture.

What are the common symptoms of code P013C in a 2016 Chevrolet Silverado?

Symptoms may include an illuminated check engine light, reduced fuel efficiency, poor engine performance, and potential emissions test failure.

What causes the P013C code to occur in a 2016 Chevrolet Silverado?

Common causes include a faulty oxygen sensor, exhaust leaks near the sensor, damaged wiring or connectors, or an overly rich or lean air-fuel mixture.

Is it safe to drive a 2016 Chevrolet Silverado with a P013C code?

While the vehicle may still be drivable, ignoring the code can lead to reduced performance, poor fuel economy, and potential damage to the catalytic converter over time.

How do you fix the P013C code on a 2016 Chevrolet Silverado?

Repairs may involve replacing the Bank 2 Sensor 2 oxygen sensor, repairing wiring or connectors, addressing exhaust leaks, or resolving fuel mixture issues.

Where is the Bank 2 Sensor 2 oxygen sensor located on a 2016 Chevrolet Silverado?

Bank 2 Sensor 2 is located on the passenger side of the exhaust system, downstream of the catalytic converter.

Can a dirty air filter cause the P013C code in a 2016 Chevrolet Silverado?

A dirty air filter is unlikely to directly cause this code, but it can contribute to improper air-fuel mixture, which may affect oxygen sensor performance.

How much does it cost to repair the P013C code in a 2016 Chevrolet Silverado?

The repair cost varies but may range from $150 to $300 for an oxygen sensor replacement, depending on labor rates and sensor pricing.

Can a P013C code be caused by bad fuel quality?

Yes, poor-quality fuel can lead to incomplete combustion and an improper air-fuel ratio, which may contribute to triggering the P013C code.

Do I need to clear the P013C code after repairs on a 2016 Chevrolet Silverado?

Yes, you should clear the code with an OBDII scanner after completing repairs to ensure the issue is resolved and to reset the check engine light.

Discuss the causes and fixes for P013C 2016 Chevrolet Silverado OBDII Code

Code P013C 2016 Chevrolet Silverado comments

No comments found for this page.

AutoCodes App

Fix Your Car Smarter

Try the New AutoCodes App!

Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.

AutoCodes App on Google Play