AutoCodes – Chevrolet – P013A 2018 Chevrolet Silverado

P013A 2018 Chevrolet Silverado Code - HO2S Slow Response Rich to Lean Bank 1 Sensor 2

Quick Answer

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Common causes include Faulty Heated Oxygen Bank 1 Sensor 2, Heated Oxygen Bank 1 Sensor 2 harness is open or shorted, Heated Oxygen Bank 1 Sensor 2 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

What it means: P013A 2018 Chevrolet Silverado indicates HO2S Slow Response Rich to Lean Bank 1 Sensor 2.
Common causes: Common causes include Faulty Heated Oxygen Bank 1 Sensor 2, Heated Oxygen Bank 1 Sensor 2 harness is open or shorted, Heated Oxygen Bank 1 Sensor 2 circuit poor electrical connection.
Severity: Moderate - service should be scheduled soon.
Can I drive?: The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 312

How popular is this code, among other codes? Low

Repair Importance Level

Moderate (Service soon) (2 / 3)

Repair Difficulty Level

Intermediate (2 / 3)

What is this?

Table of contents Created and updated by William Orellana on May 28, 2022

Description
Possible Causes
How To Fix
Tech Notes ▶
Cost to Diagnose
FAQs
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P013A 2018 Chevrolet Silverado Description

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Each HO2S compares the oxygen content of the surrounding air with the oxygen content of the exhaust stream. When the engine is started, the Engine Control Module (ECM) operates in an Open Loop mode, ignoring the HO2S signal voltage while calculating the air-to-fuel ratio. While the engine runs, the HO2S heats up and begins to generate a voltage within a range of 0 - 1, 000 mV. Once sufficient HO2S voltage fluctuation is observed by the ECM, Closed Loop is entered. The ECM uses the HO2S voltage to determine the air-to-fuel ratio. An HO2S voltage that increases toward 1, 000 mV indicates a rich fuel mixture. An HO2S voltage that decreases toward 0 mV indicates a lean fuel mixture.
The heating elements inside each HO2S heat the sensor to bring the sensor up to operating conditions faster. This allows the system to enter Closed Loop earlier and the ECM to calculate the air-to-fuel ratio sooner.
The Diagnostic Trouble Code (DTC) will be set when the ECM detects that the accumulated mass airflow monitored during rich-to-lean transitions between 450 - 150 mV is greater than calibrated value.

OBDII Code P013A 2018 Chevrolet Silverado - HO2S Slow Response Rich to Lean Bank 1 Sensor 2 - AutoCodes.com — P013A 2018 Chevrolet Silverado Code - HO2S Slow Response Rich to Lean Bank 1 Sensor 2

What does this mean?

What are the Possible Causes of the DTC P013A 2018 Chevrolet Silverado?

Faulty Heated Oxygen Bank 1 Sensor 2
Heated Oxygen Bank 1 Sensor 2 harness is open or shorted
Heated Oxygen Bank 1 Sensor 2 circuit poor electrical connection
Low or high fuel system pressure
Fuel contamination
Faulty fuel injectors
Exhaust gas leaks
Engine vacuum leaks

How to Fix the DTC P013A 2018 Chevrolet Silverado?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What does this mean?

Code Tech Notes

Replacing the Rear Heated Oxygen Sensors (HO2S) usually takes care of the problem.

User Submitted Video

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P013A 2018 Chevrolet Silverado code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P013A 2018 Chevrolet Silverado code?

Need more information on how to fix the P013A 2018 Chevrolet Silverado code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P013A 2018 Chevrolet Silverado code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P013A 2018 Chevrolet Silverado Code

1. What does the P013A OBDII code for a 2018 Chevrolet Silverado indicate?

The P013A code indicates a slow response from the oxygen sensor (HO2S) located in Bank 1 Sensor 2, signaling a rich to lean condition.

2. What are the common symptoms of the P013A code in a 2018 Chevrolet Silverado?

Common symptoms include decreased fuel efficiency, rough idling, engine misfires, and the illumination of the Check Engine Light.

3. What are the possible causes of the P013A code in a 2018 Chevrolet Silverado?

Possible causes include a faulty oxygen sensor, wiring issues in the sensor circuit, exhaust leaks, engine vacuum leaks, or an issue with the fuel system.

4. How do I diagnose the P013A code in a 2018 Chevrolet Silverado?

Diagnosis typically involves using an OBDII scanner to read the code, inspecting the oxygen sensor and its wiring, checking for exhaust or vacuum leaks, and testing the fuel system.

5. How can I repair the P013A code in a 2018 Chevrolet Silverado?

Repair options may include replacing the Bank 1 Sensor 2 oxygen sensor, repairing or replacing damaged wiring, fixing any exhaust or vacuum leaks, or addressing issues with the fuel system.

6. Can I drive my 2018 Chevrolet Silverado with the P013A code?

It is not recommended to drive your vehicle for an extended period with the P013A code present, as it can lead to decreased fuel efficiency and potential damage to the engine components.

7. How much does it cost to fix the P013A code in a 2018 Chevrolet Silverado?

The cost of repairing the P013A code can vary depending on the exact cause of the issue, but it may range from $100 to $500 or more, including parts and labor.

8. How often should I replace oxygen sensors in a 2018 Chevrolet Silverado to prevent the P013A code?

Oxygen sensors typically have a lifespan of around 60,000 to 100,000 miles. It is recommended to follow the manufacturer's guidelines for sensor replacement to prevent issues like the P013A code.

9. Are there any maintenance tips to prevent the recurrence of the P013A code in a 2018 Chevrolet Silverado?

Regular maintenance, such as timely replacement of oxygen sensors, checking for exhaust leaks, and ensuring the fuel system is in good condition, can help prevent the recurrence of the P013A code.

10. Can a DIY enthusiast fix the P013A code in a 2018 Chevrolet Silverado?

While some DIY enthusiasts may be able to diagnose and fix the P013A code themselves, it is recommended to have the necessary tools, knowledge, and experience to properly address the issue to avoid further complications.