AutoCodes – Chevrolet – P0133 2015 Chevrolet Silverado

P0133 2015 Chevrolet Silverado Code - HO2S Slow Response Bank 1 Sensor 1

Quick Answer

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Common causes include Faulty Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1, Heated Oxygen Sensor Bank 1 Sensor 1 harness is open or shorted, Heated Oxygen Sensor Bank 1 Sensor 1 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

What it means
P0133 2015 Chevrolet Silverado indicates HO2S Slow Response Bank 1 Sensor 1.
Common causes
Common causes include Faulty Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1, Heated Oxygen Sensor Bank 1 Sensor 1 harness is open or shorted, Heated Oxygen Sensor Bank 1 Sensor 1 circuit poor electrical connection.
Severity
Moderate - service should be scheduled soon.
Can I drive?
The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
AI answers can be wrong. Verify repairs with testing. Open full chat
Code Popularity 544
How popular is this code, among other codes? Low
Table of contents Created and updated by William Orellana on May 28, 2022
πŸ’¬ Need more help? Ask Coddy for instant answers β€” it's free!

Code P0133 2015 Chevrolet Silverado Description

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Each HO2S compares the oxygen content of the surrounding air with the oxygen content of the exhaust stream. When the engine is started, the Engine Control Module (ECM) operates in an Open Loop mode, ignoring the HO2S signal voltage while calculating the air-to-fuel ratio. While the engine runs, the HO2S heats up and begins to generate a voltage within a range of 0 - 1, 000 mV. Once sufficient HO2S voltage fluctuation is observed by the ECM, Closed Loop is entered. The ECM uses the HO2S voltage to determine the air-to-fuel ratio. An HO2S voltage that increases toward 1, 000 mV indicates a rich fuel mixture. An HO2S voltage that decreases toward 0 mV indicates a lean fuel mixture.
The heating elements inside each HO2S heat the sensor to bring the sensor up to operating conditions faster. This allows the system to enter Closed Loop earlier and the ECM to calculate the air-to-fuel ratio sooner.
The Diagnostic Trouble Code (DTC) will be set when the ECM detects that the HO2S 1 rich-to-lean or lean-to-rich average response time is greater than a calibrated value for greater than 60s.
OBDII Code P0133 2015 Chevrolet Silverado - HO2S Slow Response Bank 1 Sensor 1 - AutoCodes.com
P0133 2015 Chevrolet Silverado Code - HO2S Slow Response Bank 1 Sensor 1

What are the Possible Causes of the DTC P0133 2015 Chevrolet Silverado?

  • Faulty Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1
  • Heated Oxygen Sensor Bank 1 Sensor 1 harness is open or shorted
  • Heated Oxygen Sensor Bank 1 Sensor 1 circuit poor electrical connection
  • Low or high fuel system pressure
  • Fuel contamination
  • Faulty fuel injectors
  • Exhaust gas leaks
  • Engine vacuum leaks

How to Fix the DTC P0133 2015 Chevrolet Silverado?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0133 2015 Chevrolet Silverado code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P0133 2015 Chevrolet Silverado code?

Need more information on how to fix the P0133 2015 Chevrolet Silverado code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0133 2015 Chevrolet Silverado code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P0133 2015 Chevrolet Silverado Code

1. What does the OBDII code P0133 mean on a 2015 Chevrolet Silverado?

P0133 indicates that the oxygen sensor (HO2S) in Bank 1 Sensor 1 has a slow response time when switching between rich and lean fuel mixtures.

2. What are the symptoms of code P0133 in a 2015 Chevrolet Silverado?

Common symptoms include reduced fuel efficiency, a rough idle, hesitation during acceleration, and the check engine light illuminating.

3. What causes the P0133 code on a 2015 Chevrolet Silverado?

Possible causes include a failing oxygen sensor, exhaust leaks, a dirty or damaged mass air flow (MAF) sensor, or issues with the fuel system.

4. How do I locate Bank 1 Sensor 1 on a 2015 Chevrolet Silverado?

Bank 1 Sensor 1 is the upstream oxygen sensor located on the side of the engine with cylinder 1, typically before the catalytic converter.

5. Can I drive my 2015 Chevrolet Silverado with the P0133 code?

While the truck may still run, driving with this code for an extended period can lead to poor fuel economy and potential damage to the catalytic converter.

6. How can I fix the P0133 code on my 2015 Chevrolet Silverado?

Begin by inspecting and possibly replacing the oxygen sensor. Check for exhaust leaks, clean the MAF sensor, and ensure there are no issues with the fuel system.

7. How much does it cost to fix the P0133 code on a 2015 Chevrolet Silverado?

Replacing an oxygen sensor typically costs between $150 and $300, including parts and labor. Additional repairs for related issues may increase costs.

8. Can a dirty air filter cause the P0133 code on a 2015 Chevrolet Silverado?

Yes, a clogged air filter can affect the air-fuel mixture, potentially leading to a slow response from the oxygen sensor.

9. How do I prevent the P0133 code from recurring on my 2015 Chevrolet Silverado?

Regularly inspect and maintain the oxygen sensor, air filter, and fuel system components. Address exhaust leaks and keep the MAF sensor clean.

10. Will clearing the code P0133 fix the problem on my 2015 Chevrolet Silverado?

Clearing the code may temporarily turn off the check engine light, but it will not address the underlying issue causing the slow sensor response.

Discuss the causes and fixes for P0133 2015 Chevrolet Silverado OBDII Code

Code P0133 2015 Chevrolet Silverado comments

No comments found for this page.

AutoCodes App

Fix Your Car Smarter

Try the New AutoCodes App!

Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.

AutoCodes App on Google Play