P0132 2011 NISSAN ALTIMA SEDAN Code - Air Fuel Ratio Circuit High Bank 1 Sensor 1
|P0132 2011 NISSAN ALTIMA SEDAN code possible causes
- Faulty Air fuel ratio (A/F) sensor 1 bank 1
- Air fuel ratio (A/F) sensor 1 bank 1 harness is open or shorted
- Air fuel ratio (A/F) sensor 1 bank 1 circuit poor electrical connection
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks
|How do I fix the P0132 2011 NISSAN ALTIMA SEDAN code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|P0132 2011 NISSAN ALTIMA SEDAN code tech notesReplacing the Air fuel ratio (A/F) sensor 1 bank 1 usually takes care of the problem.
|Cost of diagnosing the P0132 2011 NISSAN ALTIMA SEDAN code
Labor: 1.0The cost of diagnosing the P0132 2011 NISSAN ALTIMA SEDAN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0132 2011 NISSAN ALTIMA SEDAN code detected?The Air Fuel Ratio (A/F) signal computed by Engine Control Module (ECM) from the A/F sensor 1 signal is constantly approx. 5V.
|What are P0132 2011 NISSAN ALTIMA SEDAN code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
- High Fuel Consumption
- Excessive Smoke from Exhaust
|P0132 2011 NISSAN ALTIMA SEDAN code descriptionThe Air Fuel Ratio (A/F) sensor is a planar dual-cell limit current sensor. The sensor element of the A/F sensor is the combination of a Nernst concentration cell (sensor cell) with an oxygen-pump cell, which transports ions. It has a heater in the element.
The sensor is capable of precise measurement λ= 1, but also in the lean and rich range. Together with its control electronics, the sensor outputs a clear, continuous signal throughout a wide range (0.7 < λ < air).
The exhaust gas components diffuse through the diffusion gap at the electrode of the oxygen pump and Nernst concentration cell, where they are brought to thermodynamic balance. An electronic circuit controls the pump current through the oxygen pump cell so that the composition of the exhaust gas in the diffusion gap remains constant at λ = 1. Therefore, the A/F sensor is able to indicate air/fuel ratio by this pumping of current. In addition, a heater is integrated in the sensor to ensure the required operating temperature of 700 - 800°C (1,292 - 1,472°F).
|Need more information with the P0132 2011 NISSAN ALTIMA SEDAN code?Need more information on how to fix the P0132 2011 NISSAN ALTIMA SEDAN code?
Get Access to Factory Service Manuals
|Need help with a P0132 2011 NISSAN ALTIMA SEDAN code?Get the P0132 2011 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area
|P0132 2011 NISSAN ALTIMA SEDAN code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0132 2011 Nissan Altima Sedan code? Have you replaced any parts?
Any information is appreciated. Thanks