P0130 2004 TOYOTA COROLLA Code - HO2S11 Circuit Malfunction 3ZZ-FE Engine
|P0130 2004 TOYOTA COROLLA code possible causes
- Faulty Front Heated Oxygen Sensor Bank 1
- Front Heated Oxygen Sensor Bank 1 harness is open or shorted
- Front Heated Oxygen Sensor Bank 1 circuit poor electrical connection
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks
|How do I fix the P0130 2004 TOYOTA COROLLA code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|Cost of diagnosing the P0130 2004 TOYOTA COROLLA code
Labor: 1.0The cost of diagnosing the P0130 2004 TOYOTA COROLLA code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0130 2004 TOYOTA COROLLA code detected?The response of the voltage signal from the sensor takes more than the specified time.
|What are P0130 2004 TOYOTA COROLLA code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
- High Fuel Consumption
- Excessive Smoke from Exhaust
|P0130 2004 TOYOTA COROLLA code descriptionIn order to obtain a high purification rate for the carbon monoxide (CO), hydrocarbon (HC) and nitrogen oxide
(NOx) components in the exhaust gas, a Three-Way Catalytic Converter (TWC) is used. For the most efficient use of the TWC, the air-fuel ratio must be precisely controlled so that it is always close to the stoichio-metric air-fuel ratio.
The heated oxygen sensor has the characteristic whereby its output voltage changes suddenly in the vicinity
of the stoichio-metric air-fuel ratio. This is used to detect the oxygen concentration in the exhaust gas and
provide the ECM with feedback to control the air-fuel ratio.
When the air-fuel ratio becomes lean, the oxygen concentration in the exhaust gas increases. The heated
oxygen sensor informs the ECM of the lean condition (low voltage, i.e. less than 0.45 V).
When the air-fuel ratio is richer than the stoichio-metric air-fuel level, the oxygen concentration in the exh
aaust gas is reduced. And the heated oxygen sensor informs the ECM of the rich condition (high voltage,
i.e. more than 0.45 V). The ECM judges by the voltage output of the heated oxygen sensor whether the airfuel? ratio is rich or lean and controls the injection time accordingly. If a malfunction of the heated oxygen
sensor causes an output of abnormal voltage, the ECM is unable to perform accurate air-fuel ratio control.
The heated oxygen sensor includes a heater which heats the zirconia element. The heater is controlled by
the ECM. When the intake air volume is low (the temperature of the exhaust gas is low), a current flows to
the heater in order to heat the sensor for accurate oxygen concentration detection.
|Need more information with the P0130 2004 TOYOTA COROLLA code?Need more information on how to fix the P0130 2004 TOYOTA COROLLA code? Get Access to Factory Service Manuals
|Need help with a P0130 2004 TOYOTA COROLLA code?Get the P0130 2004 Toyota Corolla code diagnosed by a professional: Find a repair shop in your area
|P0130 2004 TOYOTA COROLLA code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0130 2004 Toyota Corolla code? Have you replaced any parts?
Any information is appreciated. Thanks