AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - P0113 2010 Nissan Sentra

P0113 2010 Nissan Sentra Code - Intake Air Temperature Sensor Circuit High

- Code Popularity: 6,989 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0113 2010 Nissan Sentra?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Intake Air Temperature (IAT) sensor
  • Dirty air filter
  • Intake Air Temperature (IAT) sensor harness is open or shorted
  • Intake Air Temperature (IAT) sensor circuit poor electrical connection
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P0113 2010 Nissan Sentra?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compressed air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replace the mass air flow sensor.

Search for P0113 2010 Nissan Sentra Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0113 2010 Nissan Sentra code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

- An excessively high voltage from the sensor is sent to ECM.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0113 2010 Nissan Sentra Description

The Intake Air Temperature (IAT) sensor is built into mass air flow sensor or in some vehicles mounted to the air filter duct housing. The sensor detects intake air temperature and transmits a signal to the Engine Control Module (ECM).The temperature sensing unit uses a thermistor which is sensitive to the change in temperature. Electrical resistance of the thermistor decreases in response to the temperature rise. The Intake Air Temperature signal is used as an input for various systems in the vehicle.

OBDII Code P0113 2010 Nissan Sentra - Intake Air Temperature Sensor Circuit High - AutoCodes.com
P0113 2010 Nissan Sentra Code - Intake Air Temperature Sensor Circuit High

Need More Information on the Code?

Need more information on how to fix the P0113 2010 Nissan Sentra code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0113 2010 Nissan Sentra code diagnosed by a professional: Find a repair shop in your area

Code P0113 2010 Nissan Sentra comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0113 2010 Nissan Sentra code? Have you replaced any parts?
Any information is appreciated. Thanks