AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0104 Ford

P0104 Ford Code - Mass Or Volume Air Flow Sensor 'A' Circuit Intermittent

- Code Popularity: 39,754 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0104 Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Dirty Air Filter
  • Faulty Mass Airflow (MAF) 'A' Sensor
  • Mass Airflow 'A' Sensor harness is open or shorted
  • Mass Airflow 'A' Sensor circuit poor electrical connection
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0104 Ford?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Before replacing the Mass Air Flow (MAF) Sensor, try replacing the air filter and cleaning the Mass Air Flow Sensor with low-compressed air or a Mass Air Flow Sensor Cleaner. Reset the code and drive the vehicle. If the code comes back, you must replace the Mass Air Flow Sensor to fix the problem.

Search for P0104 Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0104 Ford code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine stall
  • Engine running rough

Code P0104 Ford Description

The Mass Airflow (MAF) Sensor uses a hot wire sensing element to measure the amount of air entering the engine. The air passing over the hot wire causes it to cool. This hot wire is maintained at 200°C (392°F) above the ambient temperature as measured by a constant cold wire. The current required to maintain the temperature of the hot wire is proportional to the mass airflow. The MAF Sensor then outputs a signal to the Powertrain Control Module (PCM) proportional to the intake air mass. The PCM calculates the required fuel injector pulse width in order to provide the desired air to fuel ratio. The MAF sensor is located near the air cleaner assembly. Most MAF sensors have an integrated Intake Air Temperature (IAT) sensor. This Diagnostic Trouble Code (DTC) will be set when a concern exists in the MAF circuit, or the air tube containing the MAF Sensor, causing an incorrect sensor output reading.
OBDII Code P0104 Ford - Mass Or Volume Air Flow Sensor 'A' Circuit Intermittent - AutoCodes.com
P0104 Ford Code - Mass Or Volume Air Flow Sensor 'A' Circuit Intermittent

Need More Information on the Code?

Need more information on how to fix the P0104 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0104 Ford code diagnosed by a professional: Find a repair shop in your area

Code P0104 Ford comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0104 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks