AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - P0100 2003 Toyota Corolla

P0100 2003 Toyota Corolla Code - Mass or Volume Air Flow Circuit 3ZZ-FE Engine

- Code Popularity: 8,754 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0100 2003 Toyota Corolla?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty mass air flow sensor
  • Intake air leaks
  • Dirty mass air flow sensor
  • Dirty mass air filter
  • Mass air flow sensor harness is open or shorted
  • Mass air flow sensor circuit poor electrical connection
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P0100 2003 Toyota Corolla?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.

Search for P0100 2003 Toyota Corolla Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0100 2003 Toyota Corolla code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

- A high voltage from the sensor is sent to Engine Control Module (ECM) under light load driving condition.
- A low voltage from the sensor is sent to ECM

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine stall
  • Engine running rough
  • Excessive fuel consumption
  • Excessive smoke

Code P0100 2003 Toyota Corolla Description

The Mass Air Flow (MAF) sensor is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. It consists of a hot film that is supplied with electric current from the Engine Control Module (ECM).
The temperature of the hot film is controlled by the ECM a certain amount. The heat generated by the hot film is reduced as the intake air flows around it. The more air, the greater the heat loss. Therefore, the ECM must supply more electric current to maintain the temperature of the hot film as air flow increases. The ECM detects the air flow by means of this current change.

OBDII Code P0100 2003 Toyota Corolla - Mass or Volume Air Flow Circuit 3ZZ-FE Engine - AutoCodes.com
P0100 2003 Toyota Corolla Code - Mass or Volume Air Flow Circuit 3ZZ-FE Engine

Need More Information on the Code?

Need more information on how to fix the P0100 2003 Toyota Corolla code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0100 2003 Toyota Corolla code diagnosed by a professional: Find a repair shop in your area

Code P0100 2003 Toyota Corolla comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0100 2003 Toyota Corolla code? Have you replaced any parts?
Any information is appreciated. Thanks