AutoCodes - Toyota - P0100 2001 TOYOTA COROLLA

P0100 2001 TOYOTA COROLLA Code - Mass or Volume Air Flow Circuit 3ZZ-FE Engine

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3
Table of contents

|P0100 2001 TOYOTA COROLLA code possible causes

  • Faulty mass air flow sensor
  • Intake air leaks
  • Dirty mass air flow sensor
  • Dirty mass air filter
  • Mass air flow sensor harness is open or shorted
  • Mass air flow sensor circuit poor electrical connection

|How do I fix the P0100 2001 TOYOTA COROLLA code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P0100 2001 TOYOTA COROLLA code tech notes

Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.

|Cost of diagnosing the P0100 2001 TOYOTA COROLLA code

Labor: 1.0

The cost of diagnosing the P0100 2001 TOYOTA COROLLA code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P0100 2001 TOYOTA COROLLA code detected?

- A high voltage from the sensor is sent to Engine Control Module (ECM) under light load driving condition.
- A low voltage from the sensor is sent to ECM

|What are P0100 2001 TOYOTA COROLLA code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine stall
  • Engine running rough
  • Excessive fuel consumption
  • Excessive smoke

|P0100 2001 TOYOTA COROLLA code description

The Mass Air Flow (MAF) sensor is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. It consists of a hot film that is supplied with electric current from the Engine Control Module (ECM).
The temperature of the hot film is controlled by the ECM a certain amount. The heat generated by the hot film is reduced as the intake air flows around it. The more air, the greater the heat loss. Therefore, the ECM must supply more electric current to maintain the temperature of the hot film as air flow increases. The ECM detects the air flow by means of this current change.
OBDII Code P0100 2001 Toyota Corolla - Mass or Volume Air Flow Circuit 3ZZ-FE Engine - AutoCodes.com

|Need more information with the P0100 2001 TOYOTA COROLLA code?

Need more information on how to fix the P0100 2001 TOYOTA COROLLA code? Get Access to Factory Service Manuals

|Need help with a P0100 2001 TOYOTA COROLLA code?

Get the P0100 2001 Toyota Corolla code diagnosed by a professional: Find a repair shop in your area

|P0100 2001 TOYOTA COROLLA code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0100 2001 Toyota Corolla code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 2
 
1=Easy 2=Moderate 3=Hard What is this?