AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0097 2011 Ford Fusion

P0097 2011 Ford Fusion Code - Intake Air Temperature Sensor 2 Circuit Low Input

- Code Popularity: 2,154 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0097 2011 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Intake Air Temperature Sensor
  • Faulty Map Senor/Intake Air Temperature Sensor 2
  • Intake Air Temperature sensor harness is open or shorted
  • Intake Air Temperature sensor circuit poor electrical connection
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0097 2011 Ford Fusion?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Try to clean the Intake Air Temperature sensor (built in the air flow meter) and the Map Senor/Intake Air Temperature sensor 2 with mass air flow sensor cleaner.

Search for P0097 2011 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0097 2011 Ford Fusion code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The Engine Control Module (ECM) has detected a low voltage condition on the Intake Air Temperature (IAT) circuit.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0097 2011 Ford Fusion Description

The Intake Air Temperature (IAT) sensor contains a semiconductor device which changes the resistance based on the temperature (a thermistor). The IAT sensor is located in the air intake passage of the engine air induction system. The IAT sensor has a signal circuit and a ground circuit. Indicates the sensor signal is less than the self-test minimum. The IAT2 sensor minimum is 0.2 volt.

OBDII Code P0097 2011 Ford Fusion - Intake Air Temperature Sensor 2 Circuit Low Input - AutoCodes.com
P0097 2011 Ford Fusion Code - Intake Air Temperature Sensor 2 Circuit Low Input

Need More Information on the Code?

Need more information on how to fix the P0097 2011 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0097 2011 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Code P0097 2011 Ford Fusion comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0097 2011 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks