P0037 2010 Nissan Rogue Code - HO2S12 Heater Control Circuit Low
Quick Answer
Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. Common causes include Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P0037 2010 Nissan Rogue indicates HO2S12 Heater Control Circuit Low.
- Common causes
- Common causes include Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P0037 2010 Nissan Rogue Description
In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
What are the Possible Causes of the DTC P0037 2010 Nissan Rogue?
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How to Fix the DTC P0037 2010 Nissan Rogue?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0037 2010 Nissan Rogue code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0037 2010 Nissan Rogue code?
Need more information on how to fix the P0037 2010 Nissan Rogue code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0037 2010 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0037 2010 Nissan Rogue Code
1. What does the OBDII code P0037 for a 2010 Nissan Rogue mean?
The code P0037 indicates a problem with the HO2S12 (Heated Oxygen Sensor 1, Bank 1) heater control circuit being low.
2. What are the common symptoms of OBDII code P0037 in a 2010 Nissan Rogue?
Common symptoms of code P0037 may include poor fuel economy, rough idling, stalling, and the illumination of the check engine light.
3. What are the possible causes of the P0037 code on a 2010 Nissan Rogue?
The P0037 code in a 2010 Nissan Rogue can be triggered by issues such as a faulty oxygen sensor, damaged wiring or connectors, a blown fuse, or a problem with the ECM.
4. How can I diagnose the HO2S12 heater control circuit low issue in my 2010 Nissan Rogue?
To diagnose the P0037 code, you may need to perform tests on the oxygen sensor, inspect the wiring for damage, check the fuse related to the sensor, and use a scan tool to monitor sensor data.
5. Can I drive my 2010 Nissan Rogue with the P0037 code?
It is generally not recommended to drive your Nissan Rogue with the P0037 code present, as it can lead to further damage and affect the vehicle's performance.
6. How do I repair the HO2S12 heater control circuit low problem in my 2010 Nissan Rogue?
Repairing the P0037 code may involve replacing the oxygen sensor, repairing damaged wiring or connectors, checking and replacing fuses if necessary, and resetting the engine control module.
7. Is it possible to clear the P0037 code on a 2010 Nissan Rogue without fixing the issue?
While you can clear the P0037 code with an OBDII scanner, it is not recommended as the underlying issue causing the fault needs to be addressed to prevent further problems.
8. How much does it cost to fix the P0037 code on a 2010 Nissan Rogue?
The cost of fixing the P0037 code on a 2010 Nissan Rogue can vary depending on the cause of the issue, but it may range from $100 to $300 or more for parts and labor.
9. How often does the HO2S12 heater control circuit low issue occur in a 2010 Nissan Rogue?
The occurrence of the P0037 code in a 2010 Nissan Rogue can vary, but it is a relatively common issue with oxygen sensors and their related circuits.
10. Can a DIY enthusiast fix the P0037 code on a 2010 Nissan Rogue?
Depending on your skill level and access to tools, a DIY enthusiast may be able to fix the P0037 code by following repair guides and tutorials specific to the Nissan Rogue model.
Discuss the causes and fixes for P0037 2010 Nissan Rogue OBDII Code
Code P0037 2010 Nissan Rogue comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
