P0037 2010 Nissan Altima Sedan Code - HO2S12 Heater Control Circuit Low
Quick Answer
Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. Common causes include Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P0037 2010 Nissan Altima Sedan indicates HO2S12 Heater Control Circuit Low.
- Common causes
- Common causes include Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P0037 2010 Nissan Altima Sedan Description
In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
What are the Possible Causes of the DTC P0037 2010 Nissan Altima Sedan?
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How to Fix the DTC P0037 2010 Nissan Altima Sedan?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0037 2010 Nissan Altima Sedan code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0037 2010 Nissan Altima Sedan code?
Need more information on how to fix the P0037 2010 Nissan Altima Sedan code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0037 2010 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0037 2010 Nissan Altima Sedan Code
1. What are common symptoms of OBDII code P0037 in a 2010 Nissan Altima Sedan?
- Common symptoms include poor fuel economy, rough idling, hesitation during acceleration, and the illumination of the Check Engine Light.
2. What does the OBDII code P0037 "HO2S12 Heater Control Circuit Low" mean for a 2010 Nissan Altima Sedan?
- This code indicates that the heating element in the oxygen sensor (HO2S12) located in bank 1 sensor 2 is not functioning properly.
3. What are some possible causes of OBDII code P0037 in a 2010 Nissan Altima Sedan?
- Potential causes include a faulty oxygen sensor, damaged wiring or connectors, a blown fuse, or issues with the engine control module (ECM).
4. How can I diagnose the root cause of OBDII code P0037 in my 2010 Nissan Altima Sedan?
- Diagnosing the issue may involve checking the oxygen sensor's resistance, inspecting the sensor's wiring and connectors for damage, and testing the related fuses.
5. What are the repair options for addressing OBDII code P0037 in a 2010 Nissan Altima Sedan?
- Repair options include replacing the faulty oxygen sensor, repairing damaged wiring or connectors, replacing blown fuses, or addressing any ECM issues.
6. Is it safe to continue driving my 2010 Nissan Altima Sedan with OBDII code P0037 present?
- It is generally not recommended to continue driving with this code unresolved, as it can lead to decreased fuel efficiency and potentially cause further damage to the vehicle.
7. Can I reset the Check Engine Light after resolving OBDII code P0037 in my 2010 Nissan Altima Sedan?
- Yes, once the underlying issue causing the code has been fixed, the Check Engine Light can be reset using an OBDII scanner or by disconnecting the vehicle's battery for a short period.
8. How much does it typically cost to repair OBDII code P0037 in a 2010 Nissan Altima Sedan?
- The cost of repair can vary depending on the exact cause of the issue and whether you choose to address it yourself or take it to a mechanic. Costs may range from around $100 to $300 or more.
9. Can a DIY enthusiast with basic automotive knowledge fix OBDII code P0037 in a 2010 Nissan Altima Sedan?
- Yes, some aspects of diagnosing and repairing this code can be tackled by individuals with basic automotive knowledge, especially if it involves tasks like replacing the oxygen sensor or checking fuses and connections.
10. How often does OBDII code P0037 occur in a 2010 Nissan Altima Sedan, and is it a common issue?
- While the frequency of this specific code may vary, heater circuit-related faults in oxygen sensors are relatively common in vehicles, including the 2010 Nissan Altima Sedan.
Discuss the causes and fixes for P0037 2010 Nissan Altima Sedan OBDII Code
Code P0037 2010 Nissan Altima Sedan comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
