P0036 VOLKSWAGEN - HO2S Heater Control Circuit Bank 1 Sensor 2
P0036 VOLKSWAGEN Possible Causes
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
First diagnose P0036 VOLKSWAGEN code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
P0036 VOLKSWAGEN Tech NotesThe code means that there is a problem with the heater element circuit of the heated oxygen sensor. The control module monitors how long it take the sensor to warm up and start sending an adequate signal. The code is triggered when the sensor is taking too long to warm up. Water getting inside the heated oxygen sensor connector can caused the heated oxygen sensor fuse to blow. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors. If the sensor and connector are OK, replacing the O2 Sensor 1 usually takes care of the problem
Cost of diagnosing the P0036 VOLKSWAGEN code
Labor: 1.0The cost of diagnosing the P0036 VOLKSWAGEN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the P0036 VOLKSWAGEN code detected?The P0036 is set when the ECM detects an open or shorted to ground condition on the heated oxygen sensor heater circuit
P0036 VOLKSWAGEN Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0036 Volkswagen DescriptionOxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).
In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
P0036 VOLKSWAGEN More InformationNeed more information on how to fix the P0036 VOLKSWAGEN code?
Get Access to Factory Service Manuals
Need more help?Get the P0036 Volkswagen code diagnosed by a professional: Find a repair shop in your area
P0036 VOLKSWAGEN CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0036 Volkswagen code? Have you replaced any parts?
Any information is appreciated. Thanks