AutoCodes – GMC – P0032 2018 GMC Sierra

P0032 2018 GMC Sierra Code - HO2S Heater Control Circuit High Voltage Bank 1 Sensor 1

Quick Answer

Heated Oxygen Sensors (HO2S) are used for fuel control and post catalyst monitoring. Common causes include Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1, Heated Oxygen Sensor Bank 1 Sensor 1 harness is open shorted to ground, Heated Oxygen Sensor Bank 1 Sensor 1 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

What it means: P0032 2018 GMC Sierra indicates HO2S Heater Control Circuit High Voltage Bank 1 Sensor 1.
Common causes: Common causes include Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1, Heated Oxygen Sensor Bank 1 Sensor 1 harness is open shorted to ground, Heated Oxygen Sensor Bank 1 Sensor 1 circuit poor electrical connection.
Severity: Moderate - service should be scheduled soon.
Can I drive?: The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 314

How popular is this code, among other codes? Low

Repair Importance Level

Moderate (Service soon) (2 / 3)

Repair Difficulty Level

Intermediate (2 / 3)

What is this?

Table of contents Created and updated by William Orellana on Mar 25, 2024

Description
Possible Causes
How To Fix
Tech Notes
Cost to Diagnose
FAQs
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P0032 2018 GMC Sierra Description

Heated Oxygen Sensors (HO2S) are used for fuel control and post catalyst monitoring. Each HO2S compares the oxygen content of the surrounding air with the oxygen content in the exhaust stream. The HO2S must reach an operating temperature to provide an accurate voltage signal. A heating element inside the HO2S minimizes the time required for the sensors to reach operating temperature. Voltage is provided to the heater by an ignition voltage circuit through a fuse. With the engine running, the ground is provided to the heater by the HO2S heater low control circuit through a low side driver within the Engine Control Module (ECM). The ECM uses Pulse Width Modulation (PWM) to control the HO2S heater operation to maintain a specific HO2S operating temperature range.
The Diagnostic Trouble Code (DTC) will be set when the ECM detects a short to voltage in the heater output low side driver circuit of the heated oxygen sensor when the heater is commanded ON for greater than 5 s.

OBDII Code P0032 2018 GMC Sierra - HO2S Heater Control Circuit High Voltage Bank 1 Sensor 1 - AutoCodes.com — P0032 2018 GMC Sierra Code - HO2S Heater Control Circuit High Voltage Bank 1 Sensor 1

What does this mean?

What are the Possible Causes of the DTC P0032 2018 GMC Sierra?

Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1
Heated Oxygen Sensor Bank 1 Sensor 1 harness is open shorted to ground
Heated Oxygen Sensor Bank 1 Sensor 1 circuit poor electrical connection
Heated Oxygen Sensor Bank 1 Sensor 1 circuit fuse
Faulty Engine Control Module (ECM)

How to Fix the DTC P0032 2018 GMC Sierra?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What does this mean?

Code Tech Notes

The code means that there is a problem with the heater element circuit of the heated oxygen sensor. The control module monitors how long it takes the sensor to warm up and start sending an adequate signal. The code is set when the sensor is taking too long to warm up. Water getting inside the heated oxygen sensor connector can cause the heated oxygen sensor fuse to blow. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors. If the fuse and connector are OK, replacing the O2 Sensor usually takes care of the problem.

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0032 2018 GMC Sierra code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P0032 2018 GMC Sierra code?

Need more information on how to fix the P0032 2018 GMC Sierra code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0032 2018 GMC Sierra code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P0032 2018 GMC Sierra Code

1. What are the common symptoms of OBDII code P0032 on a 2018 GMC Sierra?

- Common symptoms include poor fuel economy, rough idling, stalling, and the illumination of the check engine light.

2. What does the OBDII code P0032 indicate on a 2018 GMC Sierra?

- The code P0032 indicates an issue with the HO2S (Heated Oxygen Sensor) Heater Control Circuit High Voltage Bank 1 Sensor 1.

3. What are the possible causes of OBDII code P0032 on a 2018 GMC Sierra?

- Possible causes include a faulty oxygen sensor, damaged wiring or connectors, a blown fuse, or a problem with the engine control module.

4. How do I diagnose the HO2S Heater Control Circuit High Voltage error on Bank 1 Sensor 1 in a 2018 GMC Sierra?

- Diagnostic steps involve checking the oxygen sensor's heating element resistance, inspecting the sensor's wiring for damage, and testing the related fuses.

5. Can I still drive my 2018 GMC Sierra with OBDII code P0032?

- It is generally safe to drive the vehicle with code P0032, but it is recommended to have the issue diagnosed and repaired promptly to prevent further damage.

6. How do I repair OBDII code P0032 on my 2018 GMC Sierra?

- To repair the code P0032, you may need to replace the Bank 1 Sensor 1 oxygen sensor, repair damaged wiring or connectors, or address any issues with the engine control module.

7. Will OBDII code P0032 cause my 2018 GMC Sierra to fail an emissions test?

- Yes, code P0032 can cause your vehicle to fail an emissions test due to its impact on the oxygen sensor's ability to provide accurate readings to the engine control module.

8. How much does it cost to fix OBDII code P0032 on a 2018 GMC Sierra?

- The cost to fix code P0032 can vary depending on the specific issue, but it may range from $100 to $300 for parts and labor.

9. Can I reset the check engine light after fixing OBDII code P0032 on my 2018 GMC Sierra?

- Yes, you can reset the check engine light using an OBDII scanner after the issue causing code P0032 has been fixed and the repair has been completed.

10. How can I prevent OBDII code P0032 from recurring on my 2018 GMC Sierra?

- To prevent code P0032 from recurring, ensure regular maintenance of your vehicle, use quality oxygen sensors, and address any issues promptly to avoid further damage.