P0032 2008 NISSAN ROGUE - Air Fuel Ratio Sensor 1 Heater Bank 1 Control Circuit High
P0032 2008 NISSAN ROGUE Possible Causes
- Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open shorted to ground
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit fuse
- Faulty Engine Control Module (ECM)
How do I fix code P0032 2008 NISSAN ROGUE?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Cost of diagnosing the P0032 2008 NISSAN ROGUE code
Labor: 1.0The cost of diagnosing the P0032 2008 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?The P0032 is set when the ECM detects an excessively low voltage through the heated oxygen sensor heater circuit
- Engine Light ON (or Service Engine Soon Warning Light)
P0032 2008 NISSAN ROGUE DescriptionAir-Fuel Ratio (A/F)sensor need to reach a minimum operating temperature of 1200 degrees F to produce an accurate voltage signal. The faster the air-fuel ratio sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).
In order to achieve the require temperature, a heater element is included inside the air-fuel ratio sensor. The ECM controls the air-fuel ratio sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
More InformationNeed more information on how to fix the P0032 2008 NISSAN ROGUE code?
Get Access to Factory Service Manuals
Need more help?Get the P0032 2008 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0032 2008 Nissan Rogue code? Have you replaced any parts?
Any information is appreciated. Thanks