AutoCodes
 
OBDII Code List
 
P0030 CADILLAC

P0030 CADILLAC - HO2S Heater Control Circuit Bank 1 Sensor 1

Repair Importance Level: 2/3
Repair Difficulty Level: 2/3   
Comments  |  Add Comment

P0030 CADILLAC Possible Causes

  • Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit fuse
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit open shorted to ground
  • Heated Oxygen Sensor (H2OS) Bank 1 Sensor 1 circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)

First diagnose P0030 CADILLAC code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

P0030 CADILLAC Tech Notes

The code means that there is a problem with the heater element circuit of the heated oxygen sensor. The control module monitors how long it take the sensor to warm up and start sending an adequate signal. The code is triggered when the sensor is taking too long to warm up. Water getting inside the heated oxygen sensor connector can caused the heated oxygen sensor fuse to blow. Before replacing the sensor, check for the condition of the heated oxygen sensor fuse and connectors. If the sensor and connector are OK, replacing the O2 Sensor 1 usually takes care of the problem

Cost of diagnosing the P0030 CADILLAC code

    Labor: 1.0

    The cost of diagnosing the P0030 CADILLAC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the P0030 CADILLAC code detected?

The P0030 is set when the PCM detects an open or shorted to ground condition on the heated oxygen sensor heater circuit

P0030 CADILLAC Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P0030 Cadillac Description

Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. The faster the heated oxygen sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM).

In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.

The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.

OBDII Code P0030 Cadillac - HO2S Heater Control Circuit Bank 1 Sensor 1 - AutoCodes.com

P0030 CADILLAC More Information

Need more information on how to fix the P0030 CADILLAC code?
Get Access to Factory Service Manuals

Need more help?

Get the P0030 Cadillac code diagnosed by a professional: Find a repair shop in your area

Related Information

P0030 CADILLAC Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0030 Cadillac code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧