P0026 SUBARU - Intake Valve Control Solenoid Circuit Range/Performance Bank 1
- Dirty engine oil
- Low engine oil level
- Faulty intake valve control solenoid
- Intake valve control solenoid harness is open or shorted
- Intake valve control solenoid circuit poor electrical connection
When is the code detected?ECM monitors OCV stuck while cam signal is normally generating and Valve cleaning is not in progress.If the CAM Acutal Position is too high or low and Difference between Cam Actual Positionand Desired Position is higher than 20° ECM determines that a fault exists and the P0026 codes is set.
- Engine Light ON (or Service Engine Soon Warning Light)
P0026 Subaru DescriptionThe Continuously Variable Valve Timing (CVVT) system is installed to the chain sprocket of the intake camshaft. This system controls the intake camshaft to provide the optimal valve timing. The Engine Control Module (ECM) controls the Oil Control Valve(OCV), based on the signals output from mass air flow, throttle position and engine coolant temperature. The CVVT controller regulates the intake camshaft angle using oil pressure through the OCV. As result, the relative position between the camshaft and the crankshaft becomes optimal, and the engine torque improves, fuel economy improves, exhaust emissions decrease under overall driving conditions.
Need more help?Get the P0026 Subaru code diagnosed by a professional: Find a repair shop in your area
P0026 SUBARU CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0026 Subaru code? Have you replaced any parts?
Any information is appreciated. Thanks