AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0018 2011 Ford Fusion

P0018 2011 Ford Fusion Code - Crankshaft Position Camshaft Position Correlation Bank 2 Sensor 'A'

- Code Popularity: 5,268 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0018 2011 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Camshaft timing incorrectly set
  • Continuous oil flow to the Variable Camshaft Timing (VCT) piston chamber
  • Erratic camshaft position due to low oil pressure
  • Oil flow restriction in the oil passages or the VCT valve body
  • VCT solenoid stuck in position
  • Faulty Variable Camshaft Timing
  • Variable Camshaft Timing harness is open or shorted
  • Variable Camshaft Timing circuit poor electrical connection
  • Damaged camshaft position (CMP) sensor
  • Open or short in the CMP sensor circuits
  • Radio frequency interference (RFI) interference
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0018 2011 Ford Fusion?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0018 2011 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0018 2011 Ford Fusion code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0018 2011 Ford Fusion Description

The Powertrain Control Module (PCM) monitors the variable camshaft timing (VCT) position for a misalignment between the camshaft and crankshaft. The test fails when the misalignment is 1 tooth or greater. This DTC can also be set due to VCT system concerns (oil contamination or VCT solenoid stuck).

OBDII Code P0018 2011 Ford Fusion - Crankshaft Position Camshaft Position Correlation Bank 2 Sensor 'A' - AutoCodes.com
P0018 2011 Ford Fusion Code - Crankshaft Position Camshaft Position Correlation Bank 2 Sensor 'A'

Need More Information on the Code?

Need more information on how to fix the P0018 2011 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0018 2011 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Code P0018 2011 Ford Fusion comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0018 2011 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks