AutoCodes
 
OBDII Code List
 
P0016 2008 KIA SORENTO

P0016 2008 KIA SORENTO - Crankshaft Position-Camshaft Position Correction- Bank 1 Sensor 'A'

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

P0016 2008 KIA SORENTO Possible Causes

  • Faulty Crankshaft Position
  • Crankshaft Position harness is open or shorted circuit.
  • Crankshaft Position circuit poor electrical connector
  • Faulty Camshaft Position
  • Camshaft Position harness is open or shorted circuit.
  • Camshaft Position circuit poor electrical connector
  • Incorrect timing
  • Engine mechanical problems
  • Damaged Engine Control Module (ECM)

First diagnose P0016 2008 KIA SORENTO code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

Cost of diagnosing the P0016 2008 KIA SORENTO code

    Labor: 1.0

    The cost of diagnosing the P0016 2008 KIA SORENTO code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the P0016 2008 KIA SORENTO code detected?

If the relative angle between CKPS and CMPS is out of the threshold value, the ECM determines that a fault exist and it set the P0016.

P0016 2008 KIA SORENTO Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of power
  • Engine rough idle

P0016 2008 Kia Sorento Description

The Camshaft Position Sensor (CMPS) and the Crankshaft Position Sensor (CKPS) are hall effect type of sensors that generate voltage using a sensor and a target wheel. Then CMPS signal is sent to the Engine Control Module (ECM) and the ECM uses the its signal for synchronizing the firing of sequential fuel injectors. And the Crankshaft Position Sensor (CKPS) is sent to the ECM and it calculates engine RPM by using CKPS's signal and controls the injection duration and the ignition timing.
OBDII Code P0016 2008 Kia Sorento - Crankshaft Position-Camshaft Position Correction- Bank 1 Sensor 'A' - AutoCodes.com

P0016 2008 KIA SORENTO More Information

Need more information on how to fix the P0016 2008 KIA SORENTO code?
Get Access to Factory Service Manuals

Need more help?

Get the P0016 2008 Kia Sorento code diagnosed by a professional: Find a repair shop in your area

Related Information

P0016 2008 KIA SORENTO Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0016 2008 Kia Sorento code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧