AutoCodes.com | All About OBDII Engine Codes
AutoCodes - KIA - P0016 2005 KIA Sorento

P0016 2005 KIA Sorento Code - Crankshaft Position-Camshaft Position Correction- Bank 1 Sensor 'A'

- Code Popularity: 9,070 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0016 2005 KIA Sorento?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Crankshaft Position
  • Crankshaft Position harness is open or shorted circuit.
  • Crankshaft Position circuit poor electrical connector
  • Faulty Camshaft Position
  • Camshaft Position harness is open or shorted circuit.
  • Camshaft Position circuit poor electrical connector
  • Incorrect timing
  • Engine mechanical problems
  • Damaged Engine Control Module (ECM)
⚠ Does your KIA have Safety Recalls? → Check here

How to Fix the DTC P0016 2005 KIA Sorento?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0016 2005 KIA Sorento Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0016 2005 KIA Sorento code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

If the relative angle between CKPS and CMPS is out of the threshold value, the ECM determines that a fault exist and it set the P0016.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of power
  • Engine rough idle

Code P0016 2005 KIA Sorento Description

The Camshaft Position Sensor (CMPS) and the Crankshaft Position Sensor (CKPS) are hall effect type of sensors that generate voltage using a sensor and a target wheel. Then CMPS signal is sent to the Engine Control Module (ECM) and the ECM uses the its signal for synchronizing the firing of sequential fuel injectors. And the Crankshaft Position Sensor (CKPS) is sent to the ECM and it calculates engine RPM by using CKPS's signal and controls the injection duration and the ignition timing.
OBDII Code P0016 2005 KIA Sorento - Crankshaft Position-Camshaft Position Correction- Bank 1 Sensor 'A' - AutoCodes.com
P0016 2005 KIA Sorento Code - Crankshaft Position-Camshaft Position Correction- Bank 1 Sensor 'A'

Need More Information on the Code?

Need more information on how to fix the P0016 2005 KIA Sorento code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0016 2005 KIA Sorento code diagnosed by a professional: Find a repair shop in your area

Code P0016 2005 KIA Sorento comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0016 2005 KIA Sorento code? Have you replaced any parts?
Any information is appreciated. Thanks