AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Oldsmobile - P0014 Oldsmobile

P0014 Oldsmobile Code - Exhaust Camshaft Position System Performance

- Code Popularity: 1,179 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0014 Oldsmobile?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Dirty Oil
  • Low engine oil level
  • Faulty Exhaust Camshaft Position Actuator Solenoid
  • Exhaust Camshaft Position Actuator Solenoid harness is open or shorted
  • Exhaust Camshaft Position Actuator Solenoid circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Oldsmobile have Safety Recalls? → Check here

How to Fix the DTC P0014 Oldsmobile?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes





User Submitted Video

Search for P0014 Oldsmobile Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0014 Oldsmobile code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0014 Oldsmobile Description

The Camshaft Position (CMP) actuator is attached to each camshaft and is hydraulically operated in order to change the angle of the camshaft relative to Crankshaft Position (CKP). The CMP actuator solenoid is controlled by the control module. The control module sends a pulse width modulated 12-volt signal to a CMP actuator solenoid. The solenoid controls the amount of engine oil flow to a CMP actuator. The CMP actuator can change the camshaft angle a maximum of 25 degrees. The control module increases the pulse width to accomplish the desired camshaft operation.

OBDII Code P0014 Oldsmobile - Exhaust Camshaft Position System Performance - AutoCodes.com
P0014 Oldsmobile Code - Exhaust Camshaft Position System Performance

Need More Information on the Code?

Need more information on how to fix the P0014 Oldsmobile code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0014 Oldsmobile code diagnosed by a professional: Find a repair shop in your area

Code P0014 Oldsmobile comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0014 Oldsmobile code? Have you replaced any parts?
Any information is appreciated. Thanks