Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
Search for P0011 GMC Questions and Answers: Search here →
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0011 GMC code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
What are Code Possible Symptoms?
Engine Light ON (or Service Engine Soon Warning Light)
Code P0011 GMC Description
The Camshaft Position (CMP) actuator system enables the Engine Control Module (ECM) to change the timing of the camshafts while the engine is operating. The Camshaft Position Actuator Solenoid Valve signal from the ECM is Pulse Width Modulated (PWM). The ECM controls the Camshaft Position Actuator Solenoid Valve duty cycle by controlling the amount of solenoid valve ON time. The Camshaft Position Actuator Solenoid Valve controls the advance or the retard of each camshaft. The Camshaft Position Actuator Solenoid Valve controls the oil flow that applies the pressure to advance or retard the camshafts.
Ignition voltage is supplied directly to the Camshaft Position Actuator Solenoid Valve. The ECM controls the solenoid valve by grounding the control circuit with a solid-state device called a driver. The driver is equipped with a feedback circuit that is pulled up to a voltage. The ECM can determine if the control circuit is open, shorted to the ground, or shorted to a voltage by monitoring the feedback voltage.
The Diagnostic Trouble Code (DTC) will be set when the ECM detects an open solenoid circuit in the CMP actuator for greater than 1 second or a cumulative of 5 seconds when the solenoid is commanded OFF.
The ECM monitors the performance of the camshaft position (CMP) actuator system by monitoring the calibrated desired position and the actual position of the camshaft, through the 4X signal of the CMP sensor. If the difference between the actual and the desired position is greater than a calibrated angle for a calibrated amount of time, DTC P0011 will be set.
P0011 GMC Code - Intake Camshaft Position System Performance
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0011 GMC code? Have you replaced any parts? Any information is appreciated. Thanks