AutoCodes - OBDII Code List - P0011 2006 SCION XB

P0011 2006 SCION XB - Camshaft Position 'A' Timing Over-Advanced or System Performance Bank 1

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

P0011 2006 SCION XB Possible Causes

  • Low or Dirty Engine Oil
  • Variable Valve Timing (VVT) circuit is open or shorted
  • Oil Control Valve (OCV) circuit is open or shorted
  • Faulty variable valve timing (VVT)
  • Faulty oil control valve (OCV)
  • Damaged Engine Control Module (ECM)

How do I fix code P0011 2006 SCION XB?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

There is a factory service bulletin for following Scion models.

2005-2006 Scion xA
2006-2006 Scion xB
Scion Factory Service Bulletin OBDII Code P0011

Cost of diagnosing the P0011 2006 SCION XB code

Labor: 1.0

The cost of diagnosing the P0011 2006 SCION XB code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

After the ECM sends the target duty cycle signal to the OCV, the ECM monitors the OCV current to establish an actual duty cycle. The ECM determines the existence of a malfunction and sets the DTC when the actual duty cycle ratio varies from the target duty cycle ratio.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of power
  • Engine rough idle

P0011 2006 Scion Xb Description

The Engine Control Module (ECM) controls the Oil Control Valve (OCV) to regulate the intake camshaft angle. As a result of the angle change, the engine timing is advance or retard. Optimizing engine timing will help the engine improve torque and fuel economy, and the exhaust emissions decrease under overall driving conditions. The Variable Valve Timing (VVT) system includes the Oil Control Valve (OCV) and VVT controller. The ECM detects the actual intake valve timing using signals from the camshaft and crankshaft position sensors, and performs feedback control.
OBDII Code P0011 2006 Scion Xb - Camshaft Position 'A' Timing Over-Advanced or System Performance Bank 1 - AutoCodes.com

P0011 2006 SCION XB More Information

Need more information on how to fix the P0011 2006 SCION XB code?
Get Access to Factory Service Manuals

Need more help?

Get the P0011 2006 Scion Xb code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0011 2006 Scion Xb code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧