P2240 Scion Code - A/F Sensor Bank 2 Open Circuit
Quick Answer
The Air-Fuel ratio (A/F) sensor provides output voltage approximately equal to the existing air-fuel ratio. Common causes include Faulty Air/Fuel Sensor Bank 2, Air/Fuel Sensor Bank 2 harness is open or shorted, Air/Fuel Sensor Bank 2 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P2240 Scion indicates A/F Sensor Bank 2 Open Circuit.
- Common causes
- Common causes include Faulty Air/Fuel Sensor Bank 2, Air/Fuel Sensor Bank 2 harness is open or shorted, Air/Fuel Sensor Bank 2 circuit poor electrical connection.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P2240 Scion Description
The A/F sensor output voltage is used to provide feedback for the Engine Control Module (ECM) to control the air-fuel ratio.
With the A/F sensor output, the ECM can determine deviation from the stoichiometric air-fuel ratio and control proper injection time. If the A/F sensor is malfunctioning, the ECM is unable to accurately control air-fuel ratio.
The A/F sensor is equipped with a heater which heats the zirconia element. The heater is also controlled by the ECM. When the intake air volume is low (the temperature of the exhaust gas is low), current flows to the heater which heats the sensor to facilitate detection of accurate oxygen concentration.
The A/F sensor is a planar type. Compared to a conventional type, the sensor and heater portions are narrower. Because the heat of the heater is conducted through the alumina to zirconia (of the sensor portion), sensor activation is accelerated.
The code is output when there is an open or short in the A/F sensor circuit, or if A/F sensor output drops. To detect these problems, the voltage of the A/F sensor is monitored when turning the ignition switch to the ON position, and the admittance (admittance is an electrical term that indicates the ease of flow of current) is checked while driving. If the voltage of the A/F sensor is between 0.6 V and 4.5 V, it is considered normal. If the voltage is outside of the specified range, or the admittance is less than the standard value, the ECM will determine that there is a malfunction in the A/F sensor. If the same malfunction is detected in the next driving cycle, the MIL is illuminated and a DTC is set.
What are the Possible Causes of the DTC P2240 Scion?
- Faulty Air/Fuel Sensor Bank 2
- Air/Fuel Sensor Bank 2 harness is open or shorted
- Air/Fuel Sensor Bank 2 circuit poor electrical connection
- Air/Fuel Sensor Relay
- Faulty Engine Control Module (ECM)
How to Fix the DTC P2240 Scion?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P2240 Scion code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P2240 Scion code?
Need more information on how to fix the P2240 Scion code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P2240 Scion code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P2240 Scion Code
1. What does the OBDII code P2240 mean on a Scion?
P2240 indicates an "A/F Sensor Bank 2 Open Circuit," which means the engine control module (ECM) has detected an open or malfunction in the air-fuel ratio (A/F) sensor circuit for Bank 2.
2. What are common symptoms of a P2240 code on a Scion?
Symptoms may include reduced fuel efficiency, poor engine performance, rough idling, hesitation during acceleration, and an illuminated Check Engine Light.
3. What causes the P2240 code to appear in a Scion?
Common causes include a faulty A/F sensor, damaged or corroded wiring, a loose or disconnected sensor connector, or issues with the ECM.
4. Is it safe to drive my Scion with the P2240 code?
While the vehicle may still be drivable, ignoring the code can lead to poor fuel economy, increased emissions, and potential damage to other components like the catalytic converter.
5. How do I diagnose the P2240 code on my Scion?
Start by inspecting the A/F sensor wiring and connectors for damage or corrosion. Use a multimeter to check for continuity in the circuit and verify the sensor's functionality. A scan tool can also provide live data for further analysis.
6. Can a faulty A/F sensor trigger the P2240 code?
Yes, a malfunctioning air-fuel ratio sensor is one of the most common causes of this code.
7. What is Bank 2 in the context of the P2240 code?
Bank 2 refers to the side of the engine opposite Bank 1, typically the side that does not contain cylinder 1 in a V-engine layout.
8. How do I fix the P2240 code on a Scion?
Repairs may involve replacing the A/F sensor, repairing or replacing damaged wiring, cleaning corroded connectors, or reprogramming the ECM if necessary.
9. How much does it cost to repair a P2240 code on a Scion?
The cost depends on the specific issue but generally ranges from $200 to $500, including diagnostic and replacement costs for the A/F sensor if needed.
10. Can a vacuum leak cause the P2240 code?
A vacuum leak is not a direct cause of P2240, but it may contribute to air-fuel ratio issues, potentially affecting sensor readings and triggering related codes.
Discuss the causes and fixes for P2240 Scion OBDII Code
Code P2240 Scion comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
