P2135 2008 Nissan Rogue Code - Throttle Position Sensor Circuit Range/Performance
Quick Answer
Electric Throttle Control Actuator consists of throttle control motor, throttle position sensor, etc. Common causes include Faulty Electric Throttle Control Actuator (TP sensor 1 and 2), Electric Throttle Control Actuator harness is open or shorted, Electric Throttle Control Actuator circuit poor connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P2135 2008 Nissan Rogue indicates Throttle Position Sensor Circuit Range/Performance.
- Common causes
- Common causes include Faulty Electric Throttle Control Actuator (TP sensor 1 and 2), Electric Throttle Control Actuator harness is open or shorted, Electric Throttle Control Actuator circuit poor connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P2135 2008 Nissan Rogue Description
The throttle position sensor has the two sensors. These sensors are a kind of potentiometers which transform the throttle valve position into output voltage, and emit the voltage signal to the Engine Control Module (ECM). In addition, these sensors detect the opening and closing speed of the throttle valve and feed the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals and the ECM controls the throttle control motor to make the throttle valve opening angle properly in response to driving condition.
What are the Possible Causes of the DTC P2135 2008 Nissan Rogue?
- Faulty Electric Throttle Control Actuator (TP sensor 1 and 2)
- Electric Throttle Control Actuator harness is open or shorted
- Electric Throttle Control Actuator circuit poor connection
- Faulty Accelerator Pedal Position Sensor
How to Fix the DTC P2135 2008 Nissan Rogue?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
Nissan Rogue Idle Air Volume Relearn
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P2135 2008 Nissan Rogue code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P2135 2008 Nissan Rogue code?
Need more information on how to fix the P2135 2008 Nissan Rogue code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P2135 2008 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P2135 2008 Nissan Rogue Code
1. What does the OBDII code P2135 for a 2008 Nissan Rogue indicate?
The code P2135 indicates a Throttle Position Sensor Circuit Range/Performance issue in the 2008 Nissan Rogue.
2. What are common symptoms of a P2135 code in a 2008 Nissan Rogue?
Common symptoms of a P2135 code include reduced engine power, hesitation or stalling when accelerating, and the vehicle going into limp mode.
3. What are possible causes of the P2135 code in a 2008 Nissan Rogue?
Possible causes of the P2135 code include a faulty throttle position sensor, damaged wiring or connectors in the throttle position sensor circuit, or a problem with the electronic throttle control system.
4. How can I diagnose the P2135 code on a 2008 Nissan Rogue?
Diagnosing the P2135 code typically involves using an OBDII scanner to read the code, checking the throttle position sensor's voltage readings, inspecting the wiring and connectors for damage, and testing the electronic throttle control system.
5. Can I drive my 2008 Nissan Rogue with a P2135 code?
It is not recommended to drive your 2008 Nissan Rogue with a P2135 code, as it can lead to potential safety hazards and further damage to the vehicle if left unresolved.
6. How can I repair a P2135 code on a 2008 Nissan Rogue?
Repairing a P2135 code may involve replacing the throttle position sensor, repairing any damaged wiring or connectors, or recalibrating the electronic throttle control system as per manufacturer's instructions.
7. Is it possible to reset the P2135 code on a 2008 Nissan Rogue without fixing the underlying issue?
While you can clear the code with an OBDII scanner, it is not recommended to reset the P2135 code without addressing the root cause, as the issue may persist and potentially worsen over time.
8. Are there any maintenance tips to prevent the P2135 code in a 2008 Nissan Rogue?
Regularly inspecting and maintaining the throttle position sensor, wiring, and connectors, as well as following the manufacturer's recommended maintenance schedule, can help prevent issues leading to the P2135 code.
9. How much does it cost to repair a P2135 code on a 2008 Nissan Rogue?
The cost of repairing a P2135 code can vary depending on the specific issue and the labor rates of the repair shop. It is recommended to get a diagnostic assessment to determine the exact repair cost.
10. Can a DIY enthusiast fix a P2135 code on a 2008 Nissan Rogue?
While some aspects of diagnosing and repairing the P2135 code can be done by a DIY enthusiast, working with electronic throttle control systems and sensors may require specialized tools and expertise, so it's advisable to consult a professional mechanic for complex issues.
Discuss the causes and fixes for P2135 2008 Nissan Rogue OBDII Code
Code P2135 2008 Nissan Rogue comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
