P1446 Infiniti Code - EVAP Canister Vent Control Valve Close
Quick Answer
The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. Common causes include Faulty EVAP Pressure Sensor, EVAP Pressure Sensor harness is open or shorted, EVAP Pressure Sensor circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P1446 Infiniti indicates EVAP Canister Vent Control Valve Close.
- Common causes
- Common causes include Faulty EVAP Pressure Sensor, EVAP Pressure Sensor harness is open or shorted, EVAP Pressure Sensor circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P1446 Infiniti Description
This solenoid valve responds to signals from the Engine Control Module (ECM). When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system components.
This solenoid valve is used only for diagnosis, and usually, remains opened. When the vent is closed, under normal purge conditions, the evaporative emission control system is depressurized and allows EVAP Control System (Small Leak) diagnosis.
What are the Possible Causes of the DTC P1446 Infiniti?
- Faulty EVAP Pressure Sensor
- EVAP Pressure Sensor harness is open or shorted
- EVAP Pressure Sensor circuit poor electrical connection
- Blocked rubber tube to EVAP canister vent control valve
- EVAP Water separator
- EVAP canister is saturated with water
- Faulty EVAP canister vent control valve
How to Fix the DTC P1446 Infiniti?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P1446 Infiniti code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P1446 Infiniti code?
Need more information on how to fix the P1446 Infiniti code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P1446 Infiniti code diagnosed by a professional: Find a repair shop in your area
Information for Specific Infiniti Models
- P1446 2003 Infiniti G35 — EVAP Canister Vent Control Valve Close
- P1446 2004 Infiniti G35 — EVAP Canister Vent Control Valve Close
- P1446 2006 Infiniti G35 — EVAP Canister Vent Control Valve Close
Frequently Asked Questions about P1446 Infiniti Code
No Frequently Asked Questions about P1446 Infiniti Code found.
Discuss the causes and fixes for P1446 Infiniti OBDII Code
Code P1446 Infiniti comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
