AutoCodes – Honda – P1361 Honda

P1361 Honda Code - Top Dead Center Sensor 1 Intermittent Interruption

Quick Answer

The Crankshaft Position (CKP) Sensor determines the timing for fuel injection and ignition of each cylinder and also detects engine speed. Common causes include Faulty Top Dead Center Sensor 1, Top Dead Center Sensor 1 harness is open or shorted, Top Dead Center Sensor 1 circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: P1361 Honda indicates Top Dead Center Sensor 1 Intermittent Interruption.
Common causes: Common causes include Faulty Top Dead Center Sensor 1, Top Dead Center Sensor 1 harness is open or shorted, Top Dead Center Sensor 1 circuit poor electrical connection.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 208,756

How popular is this code, among other codes? High

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Advanced (Pro) (3 / 3)

What is this?

Table of contents Created and updated by William Orellana on Apr 23, 2023

Description
Possible Causes
How To Fix
Tech Notes ▶
Cost to Diagnose
FAQs
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P1361 Honda Description

The Crankshaft Position (CKP) Sensor determines the timing for fuel injection and ignition of each cylinder and also detects engine speed. The Top Dead Center (TDC) Sensor determines ignition timing at start-up (cranking) and when the crank angle is abnormal. The Cylinder Position (CYP) Sensor detects the position of the No. 1 cylinder for the sequential fuel injection to each cylinder. The CKP/TDC/CYP sensors are built into the distributor. If intermittent interruption Top Dead Center (TDC) sensor pulsing signals are detected, a malfunction is detected, and the P1382 Diagnostic Trouble Code (DTC) is stored.

OBDII Code P1361 Honda - Top Dead Center Sensor 1 Intermittent Interruption - AutoCodes.com — P1361 Honda Code - Top Dead Center Sensor 1 Intermittent Interruption

What does this mean?

What are the Possible Causes of the DTC P1361 Honda?

Faulty Top Dead Center Sensor 1
Top Dead Center Sensor 1 harness is open or shorted
Top Dead Center Sensor 1 circuit poor electrical connection

How to Fix the DTC P1361 Honda?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What does this mean?

Code Tech Notes

Some Honda models Top Dead Center (TDC) sensor location:

User Submitted Video

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1361 Honda code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P1361 Honda code?

Need more information on how to fix the P1361 Honda code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1361 Honda code diagnosed by a professional: Find a repair shop in your area

Information for Specific Honda Models

P1361 1996 Honda Civic — Top Dead Center Sensor 1 Intermittent Interruption
P1361 1997 Honda Civic — Top Dead Center Sensor 1 Intermittent Interruption
P1361 1998 Honda Civic — Top Dead Center Sensor 1 Intermittent Interruption
P1361 1999 Honda Civic — Top Dead Center Sensor 1 Intermittent Interruption
P1361 2000 Honda Civic — Top Dead Center Sensor 1 Intermittent Interruption

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P1361 Honda Code

1. What does the OBDII code P1361 mean on a Honda?

P1361 indicates an intermittent interruption in the Top Dead Center (TDC) Sensor 1 circuit, which helps the engine's computer determine the position of the crankshaft for proper timing.

2. What are the common symptoms of code P1361 on a Honda?

Symptoms may include engine misfires, rough idling, difficulty starting, reduced engine performance, or the engine stalling unexpectedly.

3. What causes the P1361 code to appear on a Honda?

Common causes include a faulty TDC sensor, damaged wiring or connectors in the sensor circuit, a failed Engine Control Module (ECM), or excessive corrosion in the electrical connections.

4. Can I still drive my Honda with a P1361 code?

Driving with a P1361 code is not recommended, as it can cause performance issues, potential stalling, and may result in further damage to the engine or other components.

5. How do I diagnose the P1361 code on a Honda?

Diagnose the issue by inspecting the TDC sensor wiring and connectors for damage or corrosion, testing the TDC sensor's resistance and signal output, and checking for proper voltage at the sensor connector.

6. How do I fix the P1361 code on a Honda?

Repairs may include replacing the faulty TDC sensor, repairing or replacing damaged wiring or connectors, cleaning corroded connections, or reprogramming or replacing the ECM if necessary.

7. Where is the Top Dead Center Sensor located on a Honda?

The TDC sensor is usually located near the camshaft or crankshaft, depending on the Honda model. Refer to your vehicle's service manual for the exact location.

8. How much does it cost to repair the P1361 code on a Honda?

Repair costs vary depending on the issue. Replacing a TDC sensor typically costs $100-$300, while wiring repairs or ECM replacements can cost more.

9. Can a dead battery cause the P1361 code on a Honda?

A dead or weak battery alone is unlikely to cause the P1361 code, but unstable voltage can affect sensor performance. Ensure the battery and charging system are in good condition.

10. Will clearing the code fix the P1361 issue on a Honda?

Clearing the code without addressing the root cause will only temporarily hide the problem. The code will return if the underlying issue is not resolved.

Discuss the causes and fixes for P1361 Honda OBDII Code

Submit a New Comment

NELSON RIOFRIO
Date: February 17, 2014 at 3:36 am

had the engine cleaned. would it get fixed once the moist dries?

Reply to Comment
OBDIITech
Date: February 17, 2014 at 3:46 am

It's very possible. Try removing the connector and dry out the moisture.

Reply to Comment
336king
Date: April 13, 2015 at 11:03 pm

I had my engine cleaned also and got this error and replace the TDC sensor crank sensor timing belt and water pump and still isn't fixed. Is there another TDC located on a 99 accord ?

Reply to Comment
OBDIITech
Date: April 14, 2015 at 8:49 pm

There is a TDC sensor and a crankshaft position sensor.

Reply to Comment
336king
Date: April 14, 2015 at 8:56 pm

Do you happen to have the part # for the TDC sensor? I called Honda and the part # they gave me is the same as the sensor I replaced but from what I was told it's also called the cam sensor. Almost wish bone shaped with two split ends going back into one connector

Reply to Comment
adedayo Omo Oba
Date: February 28, 2017 at 8:44 pm

Pls I need ur help fix this code honda civic 2001 car P1361 the car will start some time sometime the will not start and if the car start just one minint the car will cut off

Reply to Comment
adedayo Omo Oba
Date: March 7, 2017 at 11:47 pm

Honda civic 2002 P1361

Reply to Comment
OBDIITech
Date: March 8, 2017 at 12:34 am

You have to replace the Top Dead Center Sensor.

Reply to Comment
adedayo Omo Oba
Date: March 8, 2017 at 8:42 pm

pls help me location it

Reply to Comment
OBDIITech
Date: March 9, 2017 at 1:14 am

I don't have an image, service manual does not show the location.

Reply to Comment
saji
Date: November 20, 2017 at 3:25 am

do we need to replace both sensors ? Cam and Crank ?

Reply to Comment
OBDIITech
Date: November 20, 2017 at 4:59 pm

No, you need to replace the Top Dead Center Sensor.

Reply to Comment
saji
Date: November 20, 2017 at 10:59 pm

is TDC sensor is different from CAm and Crank ?

Reply to Comment
saji
Date: November 20, 2017 at 11:19 pm

I thnk TDC sensor and Cam sensor is SAME... !!

Reply to Comment
OBDIITech
Date: November 21, 2017 at 4:50 am

The TDC sensor is the same as the Camshaft Position Sensor, but its not the same as the Crankshaft Position Sensor

Reply to Comment
joseph Ojo
Date: October 12, 2019 at 7:26 pm

Which one is camshaft and crankshaft position sensor, pls me to differentiate them,and where are they located in Honda 2004

Reply to Comment
Fhree sillan
Date: February 25, 2020 at 1:40 am

Can you show us a picture of the part hat needs to be replaced thanks!

Reply to Comment
OBDIITech
Date: February 25, 2020 at 2:22 am

What model and year is you vehicle?

Reply to Comment
Fhree sillan
Date: February 25, 2020 at 2:41 am

Honda Accord EX V6 3.0L 1999. Looks exactly like the photo. Just having a hard time finding the part and how is mounted on the motor. Many thanks! Have a blessed evening.

Reply to Comment
OBDIITech
Date: February 25, 2020 at 2:46 am

Here is the only image I got. I hope that helps

Click here to enlarge image

Reply to Comment
Fhree sillan
Date: February 25, 2020 at 3:02 am

Was wondering if it's one of these pictures for the

Click here to enlarge image

Click here to enlarge image part that goes there?

Reply to Comment
OBDIITech
Date: February 25, 2020 at 3:49 am

Yes the sensor on the image is correct. For your Honda with 6 cylinder engine, the sensor is located behind the front camshaft gear and requires removing the timing belt to replace.

Reply to Comment
Fhree sillan
Date: February 25, 2020 at 3:57 am

Thanks! Lastly, the picture on the right or left as the extension is short on one and long on the other... Have a blessed evening!

Reply to Comment
charles passarotti
Date: July 20, 2021 at 6:22 pm

2002 civic ex with 1.7. replaced both the cam position senor and the crank position sensor, still getting P1361 code. any suggestions?

Reply to Comment