AutoCodes – Dodge – P1239 Dodge

P1239 Dodge Code - Engine Oil Temperature Too Low

Quick Answer

The Engine Oil Temperature (EOT) Sensor is a variable resistor that measures the temperature of the engine oil. Common causes include Engine Oil, Faulty Engine Oil Temperature Sensor, Engine Oil Temperature Sensor harness is open or shorted. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: P1239 Dodge indicates Engine Oil Temperature Too Low .
Common causes: Common causes include Engine Oil, Faulty Engine Oil Temperature Sensor, Engine Oil Temperature Sensor harness is open or shorted.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 22,284

How popular is this code, among other codes? Low

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Advanced (Pro) (3 / 3)

What is this?

Table of contents Created and updated by William Orellana on Jun 29, 2020

Description
Possible Causes
How To Fix
Tech Notes
Cost to Diagnose
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P1239 Dodge Description

The Engine Oil Temperature (EOT) Sensor is a variable resistor that measures the temperature of the engine oil. The Powertrain Control Module (PCM) supplies a 5-Volt reference and a ground to the sensors low reference signal circuit. When the oil temperature is low, the sensor resistance is high. When the oil temperature is high, the sensor resistance is low. The Diagnostic Trouble Code (DTC) P1239 is set when the Engine Oil temperature rises slower than a calibrated modeled temperature. When the actual oil temperature falls below the low boundary of the calibrated modeled temperature for three minutes the fault is set. Two trip fault. Three good trips to turn off the MIL.

OBDII Code P1239 Dodge - Engine Oil Temperature Too Low - AutoCodes.com — P1239 Dodge Code - Engine Oil Temperature Too Low

What does this mean?

What are the Possible Causes of the DTC P1239 Dodge?

Engine Oil
Faulty Engine Oil Temperature Sensor
Engine Oil Temperature Sensor harness is open or shorted
Engine Oil Temperature Sensor circuit poor electrical connection
Faulty Powertrain Control Module (PCM)

How to Fix the DTC P1239 Dodge?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What does this mean?

Code Tech Notes

There is a factory service bulletin for the following Dodge Models:
2011 Dodge Avenger
2011 Dodge Caravan
2011 Dodge Challenger
2011 Dodge Charger
2011 Dodge Journey
Dodge Factory Service Bulletin OBDII Code P1239

The bulletin recommends reprogramming the Powertrain Control Module (PCM).

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1239 Dodge code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P1239 Dodge code?

Need more information on how to fix the P1239 Dodge code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1239 Dodge code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P1239 Dodge Code

No Frequently Asked Questions about P1239 Dodge Code found.

Discuss the causes and fixes for P1239 Dodge OBDII Code

Submit a New Comment

Scot N Sarah Sterling
Date: January 8, 2018 at 1:28 am

I have a 2007 Dodge 1500 with 5.7. The original problem started with oil pressure gauge bottoming out. Truck runs fine no signs of actually losing oil pressure so I changed the oil sending unit. Didn't fix the problem. Checked for codes and it has a p1239 low oil temp. My question is if the oil temp sending unit is bad can that affect the pressure sending unit and make the gauge act all crazy???

Reply to Comment
OBDIITech
Date: January 8, 2018 at 8:05 pm

Please double check the code, I can't find any information for the P1239 in the factory service manual for you vehicle. If the number is OK, then try with another scanner.

Reply to Comment