AutoCodes – Acura – P1158 Acura

P1158 Acura Code - Air/Fuel Ratio Sensor 1 Terminal Low Voltage

Quick Answer

The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. Common causes include Faulty Air/Fuel Ratio Sensor 1, Air/Fuel Ratio Sensor 1 harness is open or shorted, Air/Fuel Ratio Sensor 1 circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: P1158 Acura indicates Air/Fuel Ratio Sensor 1 Terminal Low Voltage.
Common causes: Common causes include Faulty Air/Fuel Ratio Sensor 1, Air/Fuel Ratio Sensor 1 harness is open or shorted, Air/Fuel Ratio Sensor 1 circuit poor electrical connection.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 3,011

How popular is this code, among other codes? Low

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Intermediate (2 / 3)

What is this?

Table of contents Created and updated by William Orellana on May 03, 2019

Description
Possible Causes
How To Fix
Cost to Diagnose
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P1158 Acura Description

The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. The A/F sensor transmits output voltage to the Engine Control Module (ECM). A heater for the sensor element is embedded in the A/F sensor (sensor 1). It is activated and heats the sensor to stabilize and speed the detection of oxygen content by controlling current flowing through the heater. An increase in the current levels off as the applied voltage to the element electrode reaches a certain range because the amount of oxygen which is led through the diffusion layer is limited. The current amperage is proportional to oxygen content in the exhaust gas, so the air/fuel ratio is detected by the measurement of the current amperage. The ECM compares a set target air/fuel ratio with the detected air/fuel ratio and controls the fuel injection timing.
If the A/F sensor (sensor 1) voltage is low, the air/fuel ratio is lean, and the ECM uses A/F feedback control to issue a Rich command. If the A/F sensor (sensor 1) voltage is high, the air/fuel ratio is rich, and the ECM uses A/F feedback control to issue a Lean command.

OBDII Code P1158 Acura - Air/Fuel Ratio Sensor 1 Terminal Low Voltage - AutoCodes.com — P1158 Acura Code - Air/Fuel Ratio Sensor 1 Terminal Low Voltage

What does this mean?

What are the Possible Causes of the DTC P1158 Acura?

Faulty Air/Fuel Ratio Sensor 1
Air/Fuel Ratio Sensor 1 harness is open or shorted
Air/Fuel Ratio Sensor 1 circuit poor electrical connection

How to Fix the DTC P1158 Acura?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1158 Acura code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P1158 Acura code?

Need more information on how to fix the P1158 Acura code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1158 Acura code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.