P0755 Mazda Code - Shift Solenoid 2 Circuit failure
Quick Answer
Shift solenoid valve 2 is turned ON or OFF by the Transmission Control Module (TCM) in response to signals sent from the park/neutral position (PNP) switch, vehicle speed and Engine Control Module (ECM) (throttle opening). Common causes include Low transmission fluid level, Dirty transmission fluid, Faulty shift solenoid 2 valve. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0755 Mazda indicates Shift Solenoid 2 Circuit failure.
- Common causes
- Common causes include Low transmission fluid level, Dirty transmission fluid, Faulty shift solenoid 2 valve.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P0755 Mazda Description
What are the Possible Causes of the DTC P0755 Mazda?
- Low transmission fluid level
- Dirty transmission fluid
- Faulty shift solenoid 2 valve
- Shift solenoid 2 valve harness is open or shorted
- Shift solenoid 2 valve circuit poor electrical connection
How to Fix the DTC P0755 Mazda?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0755 Mazda code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0755 Mazda code?
Need more information on how to fix the P0755 Mazda code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0755 Mazda code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0755 Mazda Code
1. What does the OBDII code P0755 mean on a Mazda?
P0755 indicates a "Shift Solenoid 2 Circuit Failure," meaning the transmission control module (TCM) has detected an issue with the electrical circuit of shift solenoid B.
2. What are the symptoms of code P0755 in a Mazda?
Common symptoms include rough shifting, delayed gear engagement, failure to shift gears, reduced fuel efficiency, and the activation of the Check Engine Light.
3. What causes the P0755 code in a Mazda?
Potential causes include a faulty shift solenoid, damaged wiring or connectors in the solenoid circuit, low or dirty transmission fluid, or a malfunctioning transmission control module.
4. Can I drive my Mazda with a P0755 code?
While it may be possible to drive, doing so can cause further damage to the transmission. It’s best to address the issue promptly to avoid costly repairs.
5. How do I diagnose a P0755 code on my Mazda?
Start by scanning for stored codes, inspecting the shift solenoid and its wiring for damage, checking the transmission fluid level and condition, and testing the solenoid with a multimeter.
6. How much does it cost to fix a P0755 code on a Mazda?
Repair costs vary, but replacing a faulty shift solenoid typically ranges from $150 to $400, while wiring repairs or fluid changes may cost less.
7. Can low transmission fluid cause the P0755 code?
Yes, low or dirty transmission fluid can affect solenoid operation and trigger the P0755 code. Ensure the fluid is at the correct level and clean.
8. How do I fix the P0755 code on my Mazda?
Repairs may include replacing the shift solenoid, repairing damaged wiring or connectors, refilling or replacing transmission fluid, or reprogramming the TCM if needed.
9. Is the P0755 code specific to Mazdas?
No, the P0755 code is a generic OBDII code that can appear on various makes and models. However, the diagnostic and repair process may vary slightly between vehicles.
10. Can a bad TCM cause the P0755 code in a Mazda?
Yes, a malfunctioning transmission control module can fail to properly control the shift solenoid, leading to the P0755 code.
Discuss the causes and fixes for P0755 Mazda OBDII Code
Code P0755 Mazda comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
