P0443 2009 Nissan Rogue Code - EVAP Canister Purge Volume Control Solenoid Valve
Quick Answer
This system controls the flow rate of fuel vapor from the EVAP canister. Common causes include Faulty EVAP Canister Purge Volume Control Solenoid Valve, EVAP Canister Purge Volume Control Solenoid Valve harness is open or shorted, EVAP Canister Purge Volume Control Solenoid Valve circuit poor electrical connection. Severity is Low - monitor the vehicle and repair when practical. The vehicle can usually be driven if no severe symptoms are present, but symptoms should be checked before extended driving.
- What it means
- P0443 2009 Nissan Rogue indicates EVAP Canister Purge Volume Control Solenoid Valve.
- Common causes
- Common causes include Faulty EVAP Canister Purge Volume Control Solenoid Valve, EVAP Canister Purge Volume Control Solenoid Valve harness is open or shorted, EVAP Canister Purge Volume Control Solenoid Valve circuit poor electrical connection.
- Severity
- Low - monitor the vehicle and repair when practical.
- Can I drive?
- The vehicle can usually be driven if no severe symptoms are present, but symptoms should be checked before extended driving.
Code P0443 2009 Nissan Rogue Description
The EVAP canister purge volume control solenoid valve uses an ON/OFF duty to control the flow rate of fuel vapor from the EVAP canister. The EVAP canister purge volume control solenoid valve is moved by ON/OFF pulses from the ECM. The longer the ON pulse, the greater the amount of fuel vapor that will flow through the valve.
The Diagnostic Trouble Code (DTC) will set when the canister purge flow is detected during the specified driving conditions, even when the EVAP canister purge volume control solenoid valve is completely closed.
What are the Possible Causes of the DTC P0443 2009 Nissan Rogue?
- Faulty EVAP Canister Purge Volume Control Solenoid Valve
- EVAP Canister Purge Volume Control Solenoid Valve harness is open or shorted
- EVAP Canister Purge Volume Control Solenoid Valve circuit poor electrical connection
- Faulty EVAP Control System Pressure Sensor
How to Fix the DTC P0443 2009 Nissan Rogue?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0443 2009 Nissan Rogue code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0443 2009 Nissan Rogue code?
Need more information on how to fix the P0443 2009 Nissan Rogue code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0443 2009 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0443 2009 Nissan Rogue Code
1. What does the OBDII code P0443 mean for a 2009 Nissan Rogue?
P0443 indicates a malfunction in the EVAP Canister Purge Volume Control Solenoid Valve circuit, which is part of the vehicle's evaporative emissions system.
2. What are the common symptoms of code P0443 in a 2009 Nissan Rogue?
Symptoms may include an illuminated Check Engine Light, reduced fuel efficiency, rough idling, or difficulty starting the vehicle.
3. What causes the P0443 code to appear in a 2009 Nissan Rogue?
Common causes include a faulty purge solenoid valve, damaged wiring or connectors, a blown fuse, or an issue with the powertrain control module (PCM).
4. Can I drive my 2009 Nissan Rogue with a P0443 code?
While it may still be drivable, ignoring the issue can lead to reduced fuel efficiency and potential damage to the emissions system over time.
5. How do I diagnose the P0443 code in a 2009 Nissan Rogue?
Start by inspecting the purge solenoid valve and its wiring for damage or loose connections. Use a multimeter to test the valve and check the circuit for continuity or short circuits.
6. How do I fix the P0443 code on a 2009 Nissan Rogue?
Repairs may include replacing the EVAP purge solenoid valve, repairing damaged wiring, or replacing a blown fuse. If the PCM is at fault, it may need reprogramming or replacement.
7. How much does it cost to fix a P0443 code on a 2009 Nissan Rogue?
Repair costs can vary but typically range from $50 to $200, depending on whether the purge solenoid valve needs replacement or if there’s extensive wiring damage.
8. What tools are needed to fix the P0443 code on a 2009 Nissan Rogue?
Common tools include a multimeter, OBDII scanner, basic hand tools (screwdrivers, pliers, etc.), and possibly a wiring diagram for the EVAP system.
9. Can a dirty or clogged EVAP purge solenoid valve cause the P0443 code?
Yes, a clogged or dirty purge solenoid valve can restrict proper operation, leading to the P0443 code being triggered.
10. Will clearing the P0443 code with a scanner fix the issue?
Clearing the code will turn off the Check Engine Light temporarily, but the issue will likely return if the underlying problem is not addressed.
Discuss the causes and fixes for P0443 2009 Nissan Rogue OBDII Code
Code P0443 2009 Nissan Rogue comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
