P0353 2010 Toyota Camry Code - Ignition Coil 3 Primary/Secondary Circuit
Quick Answer
The DIS is a 1-cylinder ignition system in which each cylinder is ignited by one ignition coil and one spark plug is connected to the end of each secondary wiring. Common causes include Faulty Ignition Coil 3, Ignition Coil 3 harness is open or shorted, Ignition Coil 3 circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0353 2010 Toyota Camry indicates Ignition Coil 3 Primary/Secondary Circuit.
- Common causes
- Common causes include Faulty Ignition Coil 3, Ignition Coil 3 harness is open or shorted, Ignition Coil 3 circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P0353 2010 Toyota Camry Description
The ECM determines the ignition timing and transmits the ignition (IGT) signals to each cylinder. Using the IGT signal, the ECM turns the power transistor inside the igniter on and off. The power transistor, in turn, switches on and off the current to the primary coil. When the current to the primary coil is cut off, a powerful voltage is generated in the secondary coil. This voltage is applied to the spark plugs, causing them to spark inside the cylinders. As the ECM cuts the current to the primary coil, the igniter sends back an ignition confirmation (IGF) signal to the ECM, for each cylinder ignition.
What are the Possible Causes of the DTC P0353 2010 Toyota Camry?
- Faulty Ignition Coil 3
- Ignition Coil 3 harness is open or shorted
- Ignition Coil 3 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How to Fix the DTC P0353 2010 Toyota Camry?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0353 2010 Toyota Camry code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0353 2010 Toyota Camry code?
Need more information on how to fix the P0353 2010 Toyota Camry code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0353 2010 Toyota Camry code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0353 2010 Toyota Camry Code
1. What does the OBDII code P0353 mean on a 2010 Toyota Camry?
P0353 indicates an issue with the Ignition Coil 3 Primary/Secondary Circuit, which means the engine control module (ECM) is detecting a malfunction in the ignition coil for cylinder 3.
2. What are the symptoms of code P0353 on a 2010 Toyota Camry?
Common symptoms include engine misfires, poor acceleration, rough idling, decreased fuel efficiency, and potentially the illumination of the Check Engine Light.
3. What causes the P0353 code to appear on a 2010 Toyota Camry?
The code can be triggered by a faulty ignition coil, damaged wiring or connectors in the ignition coil circuit, a defective ECM, or a bad spark plug in cylinder 3.
4. How can I diagnose the P0353 code on my 2010 Toyota Camry?
Start by inspecting the ignition coil for cylinder 3, checking its wiring and connectors for damage or corrosion. Use a multimeter to test the coil's resistance and verify the ECM's signal to the coil.
5. Can I drive my 2010 Toyota Camry with a P0353 code?
Driving with a P0353 code is not recommended, as it can lead to further engine damage, poor performance, and increased emissions.
6. How do I fix the P0353 code on a 2010 Toyota Camry?
Repairs may include replacing the faulty ignition coil, repairing or replacing damaged wiring or connectors, replacing a defective spark plug, or in rare cases, replacing the ECM.
7. How much does it cost to repair the P0353 code on a 2010 Toyota Camry?
The cost varies depending on the issue. Replacing an ignition coil typically costs $50–$150 for parts and $50–$100 for labor, while more extensive repairs like ECM replacement can be much higher.
8. Can a bad spark plug cause the P0353 code on a 2010 Toyota Camry?
Yes, a bad spark plug in cylinder 3 can strain the ignition coil, causing the P0353 code to appear.
9. What tools are needed to fix the P0353 code on a 2010 Toyota Camry?
You'll need a basic socket set, a multimeter to test the ignition coil, and potentially an OBDII scanner to reset the code after repairs.
10. How do I prevent the P0353 code from returning on my 2010 Toyota Camry?
Perform regular maintenance, including inspecting and replacing spark plugs and ignition coils as needed, and addressing wiring issues promptly to prevent future problems.
Discuss the causes and fixes for P0353 2010 Toyota Camry OBDII Code
Code P0353 2010 Toyota Camry comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
