P0339 2005 Toyota Highlander Code - Crankshaft Position Sensor 'A' Circuit Intermittent
Quick Answer
The Crankshaft position sensor also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. Common causes include Faulty crankshaft position sensor, Crankshaft position sensor harness is open or shorted, Crankshaft position sensor circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0339 2005 Toyota Highlander indicates Crankshaft Position Sensor 'A' Circuit Intermittent.
- Common causes
- Common causes include Faulty crankshaft position sensor, Crankshaft position sensor harness is open or shorted, Crankshaft position sensor circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P0339 2005 Toyota Highlander Description
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
What are the Possible Causes of the DTC P0339 2005 Toyota Highlander?
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery
How to Fix the DTC P0339 2005 Toyota Highlander?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0339 2005 Toyota Highlander code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0339 2005 Toyota Highlander code?
Need more information on how to fix the P0339 2005 Toyota Highlander code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0339 2005 Toyota Highlander code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0339 2005 Toyota Highlander Code
1. What are common symptoms of OBDII code P0339 in a 2005 Toyota Highlander?
Symptoms may include rough idling, stalling, difficulty starting the engine, and decreased fuel efficiency.
2. What can cause the OBDII code P0339 in a 2005 Toyota Highlander?
The code is typically triggered by a faulty crankshaft position sensor, damaged wiring or connectors, or issues with the sensor's circuit.
3. How can I diagnose the cause of OBDII code P0339 in my 2005 Toyota Highlander?
You can start by checking the wiring and connectors for any damage, testing the sensor's resistance, and inspecting the sensor's position and alignment.
4. Can a bad crankshaft position sensor cause OBDII code P0339 in a 2005 Toyota Highlander?
Yes, a malfunctioning crankshaft position sensor can trigger this code, as it affects the signal sent to the engine control module.
5. How important is it to address OBDII code P0339 in a 2005 Toyota Highlander promptly?
It's crucial to address the issue promptly to prevent further engine problems and potential safety hazards while driving.
6. Are there any temporary fixes for OBDII code P0339 in a 2005 Toyota Highlander?
Temporary fixes such as clearing the code or resetting the engine control module may be possible but should not substitute for a proper diagnosis and repair.
7. Can I drive my 2005 Toyota Highlander with OBDII code P0339?
It's not recommended to drive the vehicle with this code present, as it can lead to performance issues and potential engine damage.
8. How much does it typically cost to repair OBDII code P0339 in a 2005 Toyota Highlander?
The cost of repair can vary depending on the exact cause, but it may range from $100 to $300 for parts and labor.
9. Is it possible to prevent OBDII code P0339 from occurring in a 2005 Toyota Highlander?
Regular maintenance and timely replacement of the crankshaft position sensor can help prevent this code from occurring.
10. Can a DIY enthusiast fix OBDII code P0339 in a 2005 Toyota Highlander?
While some enthusiasts may be able to diagnose and replace the sensor themselves, it's recommended to consult a professional mechanic for an accurate diagnosis and repair.
Discuss the causes and fixes for P0339 2005 Toyota Highlander OBDII Code
Code P0339 2005 Toyota Highlander comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
