P0335 2009 Nissan Xterra Code - Crankshaft Position Sensor Circuit
Quick Answer
The Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. Common causes include Faulty crankshaft position sensor, Crankshaft position sensor harness is open or shorted, Crankshaft position sensor circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0335 2009 Nissan Xterra indicates Crankshaft Position Sensor Circuit.
- Common causes
- Common causes include Faulty crankshaft position sensor, Crankshaft position sensor harness is open or shorted, Crankshaft position sensor circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P0335 2009 Nissan Xterra Description
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
What are the Possible Causes of the DTC P0335 2009 Nissan Xterra?
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery
How to Fix the DTC P0335 2009 Nissan Xterra?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
2005 Xterra Crankshaft Position Sensor Replacement
User Submitted Video
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0335 2009 Nissan Xterra code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0335 2009 Nissan Xterra code?
Need more information on how to fix the P0335 2009 Nissan Xterra code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0335 2009 Nissan Xterra code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0335 2009 Nissan Xterra Code
1. What are the common symptoms of a P0335 code on a 2009 Nissan Xterra?
The common symptoms of a P0335 code include engine stalling, rough idling, difficulty starting the vehicle, and decreased fuel efficiency.
2. What causes the P0335 code to appear on a 2009 Nissan Xterra?
The P0335 code on a 2009 Nissan Xterra is typically triggered by a faulty crankshaft position sensor or issues with the sensor's circuit.
3. How does the crankshaft position sensor affect the engine's performance in a 2009 Nissan Xterra?
The crankshaft position sensor provides crucial information to the engine control module (ECM) about the position of the crankshaft, aiding in proper fuel delivery and ignition timing. A malfunctioning sensor can cause various performance issues.
4. Can a faulty crankshaft position sensor be cleaned or repaired, or does it need to be replaced?
In most cases, a faulty crankshaft position sensor cannot be repaired or cleaned and will need to be replaced to resolve the P0335 code on a 2009 Nissan Xterra.
5. Are there any DIY tips for diagnosing a P0335 code on a 2009 Nissan Xterra?
DIY enthusiasts can use a multimeter to test the crankshaft position sensor's resistance and voltage output. However, if you are not confident in your abilities, it's best to seek professional assistance.
6. How much does it typically cost to replace a crankshaft position sensor on a 2009 Nissan Xterra?
The cost of replacing a crankshaft position sensor on a 2009 Nissan Xterra can vary depending on the brand of the sensor and the labor charges, but it generally ranges from $100 to $250.
7. Can a P0335 code on a 2009 Nissan Xterra cause long-term damage if left unrepaired?
Continuing to drive with a P0335 code can lead to potential long-term damage to the engine, as the ECM relies on the crankshaft position sensor for critical functions related to engine performance and efficiency.
8. Will resetting the trouble codes make the P0335 code disappear permanently on a 2009 Nissan Xterra?
Resetting the trouble codes may temporarily clear the P0335 code, but if the underlying issue with the crankshaft position sensor is not addressed, the code is likely to reappear after some driving cycles.
9. Is it safe to drive a 2009 Nissan Xterra with a P0335 code?
It is not recommended to drive a 2009 Nissan Xterra with a P0335 code, as the vehicle may experience performance issues and potentially lead to further damage if the underlying problem is not resolved.
10. How long does it typically take to replace a crankshaft position sensor on a 2009 Nissan Xterra?
Replacing a crankshaft position sensor on a 2009 Nissan Xterra usually takes about 1-2 hours, depending on the technician's experience and the accessibility of the sensor in the engine compartment.
Discuss the causes and fixes for P0335 2009 Nissan Xterra OBDII Code
Code P0335 2009 Nissan Xterra comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
