AutoCodes – Dodge – P0298 Dodge

P0298 Dodge Code - Engine Oil Temperature Too High

Quick Answer

The Engine Oil Temperature (EOT) Sensor is a variable resistor that measures the temperature of the engine oil. Common causes include Engine Oil, Faulty Engine Oil Temperature Sensor, Engine Oil Temperature Sensor harness is open or shorted. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: P0298 Dodge indicates Engine Oil Temperature Too High .
Common causes: Common causes include Engine Oil, Faulty Engine Oil Temperature Sensor, Engine Oil Temperature Sensor harness is open or shorted.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 11,088

How popular is this code, among other codes? Low

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Advanced (Pro) (3 / 3)

What is this?

Table of contents Created and updated by William Orellana on Jun 29, 2020

Description
Possible Causes
How To Fix
Tech Notes
Cost to Diagnose
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P0298 Dodge Description

The Engine Oil Temperature (EOT) Sensor is a variable resistor that measures the temperature of the engine oil. The Powertrain Control Module (PCM) supplies a 5-Volt reference and a ground to the sensors low reference signal circuit. When the oil temperature is low, the sensor resistance is high. When the oil temperature is high, the sensor resistance is low. The Diagnostic Trouble Code (DTC) P0298 is set when the Engine oil temperature rises faster than a calibrated modeled temperature. When the actual oil temperature exceeds the high boundary of the calibrated modeled temperature for three minutes the fault is set. Two trip fault. Three good trips to turn off the MIL.

OBDII Code P0298 Dodge - Engine Oil Temperature Too High - AutoCodes.com — P0298 Dodge Code - Engine Oil Temperature Too High

What does this mean?

What are the Possible Causes of the DTC P0298 Dodge?

Engine Oil
Faulty Engine Oil Temperature Sensor
Engine Oil Temperature Sensor harness is open or shorted
Engine Oil Temperature Sensor circuit poor electrical connection
Faulty Powertrain Control Module (PCM)

How to Fix the DTC P0298 Dodge?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What does this mean?

Code Tech Notes

On engines that are equipped with an oil temperature sensor, the Powertrain Control Module (PCM) reads oil temperature to determine if it is excessive. When an oil temperature sensor is not present, the PCM uses an oil algorithm to infer the actual temperature. Engine shutdown strategy function is the same on vehicles with and without oil temperature sensors.

There is a factory service bulletin for the following Dodge Models:
2011 Dodge Avenger
2011 Dodge Caravan
2011 Dodge Challenger
2011 Dodge Charger
2011 Dodge Journey
Dodge Factory Service Bulletin OBDII Code P0298

The bulletin recommends reprogramming the Powertrain Control Module (PCM).

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0298 Dodge code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P0298 Dodge code?

Need more information on how to fix the P0298 Dodge code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0298 Dodge code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.