P0133 2010 Nissan Rogue Code - Air Fuel Ratio Circuit Slow Response Bank 1 Sensor 1
Quick Answer
The Air Fuel Ratio (A/F) sensor is a planar dual-cell limit current sensor. Common causes include Faulty Air fuel ratio (A/F) sensor 1 bank 1, Air fuel ratio (A/F) sensor 1 bank 1 harness is open or shorted, Air fuel ratio (A/F) sensor 1 bank 1 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P0133 2010 Nissan Rogue indicates Air Fuel Ratio Circuit Slow Response Bank 1 Sensor 1.
- Common causes
- Common causes include Faulty Air fuel ratio (A/F) sensor 1 bank 1, Air fuel ratio (A/F) sensor 1 bank 1 harness is open or shorted, Air fuel ratio (A/F) sensor 1 bank 1 circuit poor electrical connection.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P0133 2010 Nissan Rogue Description
The sensor is capable of precise measurement λ= 1, but also in the lean and rich range. Together with its control electronics, the sensor outputs a clear, continuous signal throughout a wide range (0.7 < λ < air).
The exhaust gas components diffuse through the diffusion gap at the electrode of the oxygen pump and Nernst concentration cell, where they are brought to thermodynamic balance. An electronic circuit controls the pump current through the oxygen pump cell so that the composition of the exhaust gas in the diffusion gap remains constant at λ = 1. Therefore, the A/F sensor is able to indicate air/fuel ratio by this pumping of current. In addition, a heater is integrated in the sensor to ensure the required operating temperature of 700 - 800°C (1,292 - 1,472°F).
What are the Possible Causes of the DTC P0133 2010 Nissan Rogue?
- Faulty Air fuel ratio (A/F) sensor 1 bank 1
- Air fuel ratio (A/F) sensor 1 bank 1 harness is open or shorted
- Air fuel ratio (A/F) sensor 1 bank 1 circuit poor electrical connection
- Inappropriate fuel pressure
- Faulty fuel injectors
- Intake air leaks may be faulty
- Exhaust gas leaks
How to Fix the DTC P0133 2010 Nissan Rogue?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0133 2010 Nissan Rogue code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0133 2010 Nissan Rogue code?
Need more information on how to fix the P0133 2010 Nissan Rogue code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0133 2010 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0133 2010 Nissan Rogue Code
1. What are the common symptoms of OBDII code P0133 on a 2010 Nissan Rogue?
The common symptoms of code P0133 include decreased fuel efficiency, rough idling, and the illumination of the Check Engine Light.
2. What does the OBDII code P0133 - Air Fuel Ratio Circuit Slow Response Bank 1 Sensor 1 mean for a 2010 Nissan Rogue?
This code indicates that the oxygen sensor in Bank 1 Sensor 1 is not responding as quickly as expected, affecting the air-fuel ratio in the engine.
3. What are the possible causes of code P0133 on a 2010 Nissan Rogue?
Potential causes of P0133 include a faulty oxygen sensor, wiring issues in the sensor circuit, vacuum leaks, exhaust system leaks, or engine misfires.
4. How can I diagnose the OBDII code P0133 on my 2010 Nissan Rogue?
Diagnosing code P0133 involves inspecting the oxygen sensor, checking for wiring damage, conducting a visual inspection of the exhaust system, and addressing any potential vacuum or engine issues.
5. Can I drive my 2010 Nissan Rogue with OBDII code P0133?
While the vehicle may still be drivable with code P0133, it is recommended to address the issue promptly to prevent potential engine damage and to ensure optimal performance and fuel efficiency.
6. How can I repair OBDII code P0133 on a 2010 Nissan Rogue?
Repairing code P0133 typically involves replacing the Bank 1 Sensor 1 oxygen sensor, repairing any damaged wiring, fixing vacuum leaks, addressing exhaust leaks, or resolving any engine misfire issues.
7. What are the long-term effects of ignoring OBDII code P0133 on a 2010 Nissan Rogue?
Ignoring code P0133 can lead to decreased fuel efficiency, potential damage to the catalytic converter, reduced engine performance, and further issues with emissions control.
8. Can a DIY enthusiast fix OBDII code P0133 on a 2010 Nissan Rogue?
While some DIY enthusiasts may be able to replace the oxygen sensor themselves, diagnosing and repairing other underlying causes of P0133 may require professional expertise and specialized tools.
9. How much does it cost to fix OBDII code P0133 on a 2010 Nissan Rogue?
The cost of repairing code P0133 can vary depending on the root cause of the issue, but it typically involves the cost of parts such as the oxygen sensor and potential labor charges if professional help is needed.
10. How often does OBDII code P0133 occur in a 2010 Nissan Rogue?
Code P0133 can occur sporadically or more frequently depending on the driving conditions, maintenance history, and overall health of the vehicle's oxygen sensor and related components.
Discuss the causes and fixes for P0133 2010 Nissan Rogue OBDII Code
Code P0133 2010 Nissan Rogue comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
