P0037 2011 Nissan Altima Sedan Code - HO2S12 Heater Control Circuit Low
Quick Answer
Oxygen Sensors (O2S) or Heated Oxygen Sensors (HO2S) need to reach a minimum operating temperature of 750 degrees F to produce an accurate voltage signal. Common causes include Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P0037 2011 Nissan Altima Sedan indicates HO2S12 Heater Control Circuit Low.
- Common causes
- Common causes include Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse, Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P0037 2011 Nissan Altima Sedan Description
In order to achieve the require temperature, a heater element is included inside the heated oxygen sensor. The ECM controls the heated oxygen sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
What are the Possible Causes of the DTC P0037 2011 Nissan Altima Sedan?
- Faulty Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 fuse
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 harness is open or shorted
- Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How to Fix the DTC P0037 2011 Nissan Altima Sedan?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0037 2011 Nissan Altima Sedan code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0037 2011 Nissan Altima Sedan code?
Need more information on how to fix the P0037 2011 Nissan Altima Sedan code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0037 2011 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0037 2011 Nissan Altima Sedan Code
1. What are the common symptoms of OBDII code P0037 in a 2011 Nissan Altima Sedan?
The common symptoms of code P0037 in a 2011 Nissan Altima Sedan include poor fuel economy, rough idling, and potential stalling of the engine.
2. What does the OBDII code P0037 "HO2S12 Heater Control Circuit Low" mean in a 2011 Nissan Altima Sedan?
The code P0037 indicates that there is a malfunction in the heater control circuit of the oxygen sensor located in bank 1 sensor 2 (HO2S12) in a 2011 Nissan Altima Sedan.
3. What are the possible causes of OBDII code P0037 in a 2011 Nissan Altima Sedan?
Possible causes of code P0037 in a 2011 Nissan Altima Sedan include a faulty oxygen sensor, damaged wiring or connectors, a blown fuse, or issues with the engine control module.
4. How can I diagnose OBDII code P0037 in my 2011 Nissan Altima Sedan?
Diagnosing code P0037 involves checking the oxygen sensor connections, inspecting the wiring for any damage, testing the sensor heater circuit, and scanning the vehicle's computer for additional fault codes.
5. Can I continue driving my 2011 Nissan Altima Sedan with OBDII code P0037?
It is not recommended to continue driving your 2011 Nissan Altima Sedan with code P0037, as it can lead to further damage to the engine and emissions system. It is best to address the issue promptly.
6. How can I repair OBDII code P0037 in my 2011 Nissan Altima Sedan?
Repairing code P0037 involves replacing the faulty oxygen sensor, repairing any damaged wiring or connectors, checking and replacing any blown fuses, and resetting the fault codes using a diagnostic scanner.
7. Is it possible to clear OBDII code P0037 in a 2011 Nissan Altima Sedan and see if it comes back?
Yes, you can clear the code using a diagnostic scanner to see if it returns. However, it is important to address the underlying issue causing the code to prevent potential engine problems.
8. How much does it cost to fix OBDII code P0037 in a 2011 Nissan Altima Sedan?
The cost of fixing code P0037 can vary depending on the cause of the issue. Replacing the oxygen sensor or repairing wiring may cost between $100 to $300, including parts and labor.
9. Can a DIY enthusiast repair OBDII code P0037 in a 2011 Nissan Altima Sedan?
While some aspects of diagnosing and repairing code P0037 can be done by a DIY enthusiast, it is recommended to have a professional mechanic perform the repairs to ensure the issue is properly resolved.
10. How often does OBDII code P0037 occur in a 2011 Nissan Altima Sedan?
Code P0037 "HO2S12 Heater Control Circuit Low" can occur sporadically in a 2011 Nissan Altima Sedan due to various factors such as sensor wear, electrical issues, or environmental conditions.
Discuss the causes and fixes for P0037 2011 Nissan Altima Sedan OBDII Code
Code P0037 2011 Nissan Altima Sedan comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
